User manual SIEMENS KA58NA45

[. . . ] Switching off and disconnecting the appliance . 23 en Safety and warning information Before you switch ON the appliance Please read the operating and installation instructions carefully. They contain important information on how to install, use and maintain the appliance. The manufacturer is not liable for any damage caused by users ignoring the information and warnings contained in the instructions for use. [. . . ] s Press a suitable receptacle against the dispenser pad. Note: - Remove the receptacle from the dispenser pad when it is approx. Ice in the discharge may cause the receptacle to overflow or block the discharge. - After switching over from dispensing ice cubes to crushed ice, the disĆ penser may still contain whole ice cubes or pieces of ice cube. These will be dispensed with the first portions of crushed ice. When switching on your new appliance, observe the following When the appliance has been conĆ nected, there are still air bubbles in the lines. Run off drinking water and pour away until water can be dispensed without bubbles. When using the ice maker for the first time, do not use the first 30Ć40 ice cubes for reasons of hygiene. 32 en Removing and cleaning the water collecting tray Spilled water collects in the water collecting tray. The water collecting tray can be emptied and cleaned by pulling it out. Disconnecting the ice cube maker If ice cubes are not to be dispensed for longer than 1 week (e. Holiday), temporarily disconnect the ice cube maker to prevent the ice cubes from freezing together. Changing the filter S Caution: unplug the appliance or switch off the circuit breaker. S Disconnect the water supply to the appliance. Removing and cleaning the ice cube container If ice cubes have not been dispensed for a prolonged period, they will shrink, have a stale taste and stick together. S Pull out the container, empty and clean with lukewarm water. S Thoroughly dry the container and screw conveyor to prevent new ice cubes from sticking. S Press the Ice maker" lock button. S Remove the ice cube container, empty and reĆinsert. Ensure that the ice cube container engages with the support. Switching on the ice cube maker again: S Press Ice maker" lock button. Inserting the ice cube container S Push the ice cube container all the way back onto the supports until it locks into position. [. . . ] S Unscrew, drain and screw back hose (2) and then hose (3) on the appliance connection valve. Important: Do not mix up the hose connections!S After draining the water tank, reĆ attach the motor compartment cover. Switch on the appliance and then turn on the tap. [. . . ]