User manual SIEMENS KS40U630GB

[. . . ] Please contribute to a better environment by disposing of packaging materials in an environmentally friendly manner. Please ask your dealer or inquire at your local authority about current means of disposal. Before you switch ON the appliance Please read the operating and installation instructions carefully. They contain important information on how to install, use and maintain the appliance. Keep all documentation for subsequent use or for the next owner. Technical safety S This appliance contains a small quantity of environmentally friendly but flammable R600a refrigerant. [. . . ] Before placing large quantities of fresh food (more than 2 kg) in the freezer compartment, switch on "fast freeze". To utilise the maximum freezing capacity, switch on "fast freeze" 24 hours in advance. 2½ days the freezer automatically switches back to the temperature set before "fast freeze". 7 Temperature display freezer compartment The figures next to the temperature display lamps indicate freezer compartment temperatures in °C. The lit lamp indicates the selected temperature. 6 en ventilated room. The installation location should neither be exposed to direct sunlight nor near a heat source, e. g. If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances to a heat source: 3 cm to an electric cooker. Appliances with fitted handles must be situated at least 55 mm from the wall on the hinge side so that the door can be opened by 90°. Installing the appliance Connecting the appliance Install the appliance in a dry, well After installing the appliance, wait at least. ½ hour before switching on the appliance. During transportation the oil in the compressor may have flowed into the refrigeration system. Before switching on the appliance for the first time, clean the interior (see Cleaning). Connect the appliance to 220 240 V/50 Hz alternating current via a correctly installed earthed socket. This will retain the aroma, colour and freshness of the food. Transfer of flavour and discoloration of the plastic parts will also be prevented. S Allow warm food and drinks to cool down before placing in the appliance!S Do not block air outlet openings with food, otherwise the air circulation will be impaired. Food which is stored directly in front of the air outlet openings may be frozen by the cold air flowing out. We recommend arranging the food as follows: S In the freezer compartment: Frozen food, ice cubes, ice cream S In the chiller compartment: Fish, meat and sausage S On the shelves in the refrigerator compartment (from top to bottom): cakes and pastries, ready meals, dairy products, meat and sausage S In the vegetable container: vegetables, salad, fruit. S In the door (from top to bottom): butter, cheese, eggs, tubes, small bottles, large bottles, milk, juice cartons. Temperature indicator (Not all models) The temperature indicator indicates temperatures below +4 °C and is used to determine the required setting of the temperature controller. Depending on the room temperature, set temperature controller between 2 and 3. If a degree precision setting is possible, set appliance to +4 °C or colder. 12 hours, when the temperature has dropped below +4 °C OK" is indicated (if this does not occur, gradually set the temperature colder). Correct setting Temperature too high, set temperature colder. Usable capacity Information on the usable capacity can be found inside your appliance on the rating plate. 9 en Interior fittings Shelves/containers If required, you can reposition the interior shelves and containers in the door: Pull shelf forwards, lower and swing out to the side. Lift the container and remove. Pull out drawer Fig. [. . . ] Fault Temperature differs greatly from the set value. Possible cause Remedial action In some cases it is adequate to switch off the appliance for 2 minutes. If the temperature still differs try again after an hour. If the temperature is too high, wait a few hours and check whether the temperature has approached the set value. [. . . ]