User manual SIEMENS LB55564GB/01 INSTALLATION INSTRUCTIONS

[. . . ] Safe operation is possible provided that the underpressure in the room where the burner is installed does not exceed 4 Pa (0. 04 mbar). This can be achieved if combustion air can flow through non-lockable openings, e. g. in doors, windows and via the airintake/exhaust-air wall box or by other technical measures, such as reciprocal interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. [. . . ] Cleaning the metal filter: Under normal operating conditions (1 to 2 hours per day), the metal grease filter will require cleaning after 8 to 10 weeks. The filter can be cleaned in a dishwasher. This can however cause slight discoloration. Important: Metal filters that are heavily saturated with grease should not be cleaned at the same time as any crockery, etc. If the filter mat is going to be cleaned by hand, soak it first of all in a hot detergent solution for several hours. Clean the filter with a brush, rinse it off thoroughly and allow it to drip dry. In so doing you will be ensuring that the extractor hood performs as effectively as possible. Press the retaining spring and remove the filter frame. 3. Remove the wire grille and replace the filter mat. Removing and installing the grease filter Extractor hoods with a filter mat: 1. Rotate the handles on the left and right of the filter grille. 4. Install the filter frame in reverse sequence. If the hood is extremely dirty (older stains), use a liquid window cleaner. Do not scratch off dried-on dirt, but wipe off with a damp cloth. Warning: Clean the control buttons with a mild detergent solution and a soft, damp cloth only. Painted, aluminium and plastic surfaces: Do not use scouring agents or abrasive sponges. Do not use corrosive, acidic or alkaline cleaning agents. Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Ensure that the kitchen is adequately ventilated. Avoid naked flames. Changing the bulbs Candle bulbs: 1. Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. Replace the bulb (standard filament bulbs, max. See grease filter. 8 Cleaning and care Halogen bulbs: 1. [. . . ] inner diameter of at least 150 mm Flat ducts must have an inner crosssection equivalent to round pipes which have an inner diameter of 120/150 mm. 177 cm2 If pipe diameters differ: use sealing strip. Ensure an adequate air supply for exhaust-air mode. Extractor hoods with 150 mm Ø air outlet: 150 mm l extraction pipe Screw the reducing connector (see optional accessories on the last page) onto the air outlet. [. . . ]