User manual SIEMENS POWERJET4 annexe 1

[. . . ] ­ Rotate programme selector by one notch to the left or to the right. The salt refill indicator $ flashes and the display 6 is lit (= Setting 1). Change the setting as follows: ­ Rotate programme selector until the required setting has been selected. [. . . ] Energy consumption in kWh Deviations are possible in practice. Water consumption in litres Start programme Here we go . . . 9 Switch off the appliance Everything o. k. . . . 87 0:15 0, 05 3 Additional options ** Flexibility . . . Y Express Wash . . . is obtained by increased energy consumption at a constant cleaning performance. · Hygiene . . . the temperature is increased during the final rinse process. ** depending on model ¿ Extra drying . . . improves the drying result by increased temperature in the final rinse. (Please take care with delicate dishes. ) Maintenance and care Filters . . . Rotate filter cylinder, remove filter system . . . For perfect rinsing results . . . Screw on filter system NOTE MARK! Cleaning waste water pump ­ Pull out the mains plug. ­ Remove filters and scoop out water. ­ Loosen screws on the pump cover (Torx T20). ­ Check area around the fan impeller for foreign objects. remove blockages/ deposits. pull lower arm upwards . . . clean spray nozzles under running water (if required use toothpicks) . . . insert spray arm . . . Rectifying minor faults yourself . . . Fault Display "6" is lit . . . If the flow rate is less, replace the supply fitting. Install supply hose without kinks. More information can be found in the operating instructions Possible causes Supply fitting jammed or calcified Fault Utensils are not clean Sand or gritty residue on the utensils Possible causes Utensils are situated close together or one above the other Too little detergent Unsuitable programme selected Spray arm nozzles blocked Filters dirty, not seated firmly Spray arms blocked Remedial action Separate the utensils, prevent contact points. [. . . ] Unplug appliance. Residual water in the appliance The programme has not yet ended Close the appliance and switch it on or terminate the programme (see Terminating the programme). Glasses not dishwasher-proof Use dishwasher-proof glasses. Use a detergent suitable for glasses. Rust on the cutlery Cutlery not rust-resistant Hard knife blades are more susceptible Extraneous rust Use dishwasher-proof cutlery. Never wash rusting parts in the appliance. Plastic/utensils discoloured Too little detergent Discoloration caused by food colourings (tomato sauce) Follow manufacturer's instructions (detergent). [. . . ]