User manual SIEMENS PROPOCKET

[. . . ] Read and follow the instructions of this user guide to avoid injuries or damage to remote control. Symbols: Be aware of information marked with the warning symbol WARNING, CAUTION or NOTICE!WARNING points out a situation that could lead to serious injuries, CAUTION indicates a situation that could lead to minor and moderate injuries. NOTICE NOTICE indicates possible property damage. [. . . ] Return them to your Hearing Care Professional for environmentally correct disposal. WARNING Choking hazard posed by small parts. Keep batteries and remote control out of children`s reach. If swallowed consult a physician or hospital immediately. 8 Changingthebatteries 7 The remote control ist powered by two AAAA batteries. the rippled part on the cover of the remote control battery compartment to slide it open. Insert two batteries as shown in the picture. Make sure the polarity symbols on the battery and compartment are aligned. A click is audible when the battery compartement is fully closed. Press + + 9 8 Keylock The key lock deactivates the buttons on the remote control so that accidentally pressing the buttons will not have any effect. Lock Slide the control over so the green section is covered. When pressing a button the LED blinks 3 times to indicate that the key lock is activated. Unlock the control to the other direction, so the green section shows. The remote control works and the LED blinks only once when pressing a button. Slide 10 Turningyourhearinginstrumentsonandoff 9 sure the distance between your remote control and hearing instrument does not exceed 40 inches (1 meter). If you are wearing two hearing instruments, both instruments will be turned on/ off at the same time. Press Make the On/Off button to turn your hearing instruments on. the On/Off button to turn your hearing instruments off. Press 11 10 Adjustingthevolume Make sure the distance between your remote control and hearing instrument does not exceed 40 inches (1 meter). If you are wearing two hearing instruments, the volume will be changed on both instruments at the same time. Press the "Volume up" (+) button to increase the volume of your hearing instruments. Press the "Volume down" (-) button to decrease the volume of your hearing instruments. Your Hearing Care Professional can activate acoustic signals to indicate when the volume has been changed and when the volume limits have been reached. 12 Changingtheprogram 11 Make sure the distance between your remote control and hearing instrument does not exceed 40 inches (1 meter). If you are wearing two hearing instruments, the program will be changed on both instruments at the same time. Each time you press the program button, your hearing instruments switch to the next program, confirming each change with an acoustic signal. Example The hearing instruments are in program 1. Your Hearing Care Professional can deactivate the acoustic signals to indicate when the program has been changed. 13 12 Maintenanceandcare Protection Use the "cover" (see "Accessories" section) to protect against accidental drips or splashes when you go near water such as a sink. Cleaning NOTICE Do NOT put your remote control in water!The cover does NOT make your remote control waterproof. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. [. . . ]