User manual SIEMENS SBIKBM02

[. . . ] Operating instructions Dishwasher IGS 6609 9000 423 582 (8906) ABC 7 8 9 10 Reset 3 sec. Start 1 2 3 4 5 6 20 21 22 23 24 25 26 27 28 29 30 31 en Table of contents Washing the dishes . 15 15 15 15 15 16 16 16 16 16 16 17 17 17 17 18 18 19 19 19 19 20 20 21 22 22 22 23 23 23 23 23 24 24 24 24 25 25 25 Safety instructions . 7 Switching off water softening system . 8 Switching off rinse aid refill indicator . [. . . ] The programme starts running. Ï Intensive zone * Perfect for a mixed load. You can wash very soiled pots and pans in the lower basket together with normally soiled utensils in the upper basket. The spray pressure in the lower basket is intensified, the rinsing temperature is increased slightly. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display )". The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). ¿ Extra drying * An increased temperature during the final rinse and an extended drying phase ensure that even plastic parts dry better. There is a slight increase in the energy consumption. 15 en Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press button @ + until the digital display )" jumps to : . ­ Press @ + or ­ button until the displayed time corresponds with your requirements. ­ Press START button P, timer programming is activated. ­ To delete timer programming, press the @ + or ­ button until )" : is indicated on the digital display. You can change your programme selection at any time until the programme starts. Interrupting the programme ­ Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. Terminating the programme (Reset) ­ Press START button P for approx. The numerical display )" indicates : . ­ The programme sequence lasts approx. On the digital display )" is indicated : . ­ Switch off ON/OFF switch (. End of programme The programme has ended when the value : is indicated on the numerical display )". Switching off the appliance Short time after the end of the programme: ­ Switch off ON/OFF switch (. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. Changing the programme When the START button P has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. 16 en Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Close the door. [. . . ] ­ The connection may be modified by technicians only. ­ A power cord extension may be purchased from customer service only. ­ Use only a residual current operated circuit-breaker which features the symbol , . Only this extension guarantees compliance with the currently valid regulations. [. . . ]