User manual SIEMENS SBVPEE01

[. . . ] Manual GVW991/P01 GVW691/P01 9000 405 908 (8812-1) en Index 4 4 4 4 4 4 4 5 5 5 5 6 6 6 7 7 7 8 8 8 9 9 9 9 9 9 10 10 10 10 11 11 12 13 14 14 14 15 15 15 Hygiene . Terminating the programme (Reset) Changing the programme . Overall condition of the machine Filters . 15 15 15 15 15 15 15 16 16 16 16 17 17 17 17 17 18 18 19 19 19 19 20 21 22 22 22 23 23 23 23 24 24 24 24 25 25 25 Safety instructions . [. . . ] The preselected starting time is activated. To delete the preselected starting time, keep pressing the Preselected starting time button 2 until none of the displays 3 h, 6 h or 9 h is lit. You can change your programme selection at any time until the programme starts. Change the setting as follows: ress button < 5 until the required setting has been selected. Close the door. Switching off the appliance Short time after the end of the programme: Open the door. Turn off the tap (not applicable if Aqua-Stop fitted). Remove the utensils when they have cooled down. Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. End of programme The programme has ended when the End display 8 is lit. The end of the programme is also indicated by an acoustic signal. The buzzer volume can be set in 4 stages. Accordingly 0, 1, 2 or 3 displays are lit. This function can be changed as follows: Open the door. Hold down button > 6 and press Start button 9 until the End display 8 and salt refill indicator 11 flash. Keep pressing button > 6 until the salt refill indicator 11 and rinse aid refill indicator 10 flash. The refill indicator 11 flashes and the displays 10 and A are B lit (= setting 2). The set buzzer volume can be heard. Interrupting the programme Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. To continue the programme, switch on the ON/OFF switch 1 again. Close the door. 16 en Terminating the programme (Reset) Open the door. The remaining programme sequence lasts approx. [. . . ] Please note the system will function only when the power supply is connected. Transportation Empty the dishwasher and secure loose parts. Drain the appliance according to the following steps: Turn on the tap. The displays of the last selected programme light up. Select programme 4 with the highest temperature button < 5 . [. . . ]