User manual SIEMENS SK75M531EU annexe 1

[. . . ] 9000442366 (8908) en Operating instructions S ABC6 7 8 9 Reset 3 sec. 1 2 3 4 5 20 21 22 23 24 25 26 27 28 en Table of contents Washing the dishes . Protection against frost (Emptying the appliance) . 13 13 13 13 13 14 14 14 14 14 14 15 15 15 15 16 16 17 17 17 17 18 18 18 19 20 20 20 20 21 21 21 21 21 22 22 22 22 22 Safety instructions . 7 Switching off water softening system . [. . . ] If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. Terminating the programme (Reset) ­ Press START button H for approx. ­ The programme sequence lasts approx. On the digital display h is indicated : . ­ Switch off ON/OFF switch (. End of programme The programme has ended when the value : is indicated on the numerical display h. Switching off the appliance Short time after the end of the programme: ­ Switch off ON/OFF switch (. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. Changing the programme When the START button H has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. 14 en Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Close the door. ­ Hold down programme button # and press START button H until the digital display h : . . . The LED for button # flashes and the digital display h displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display h. To change the setting, ­ Press the button 3 to switch the Intensive drying on : or off : . The set value is saved. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. ­ Regularly clean door seal with a damp cloth. Never use a steam cleaner to clean your dishwasher. [. . . ] The expected programme duration is indicated on the numerical display h. 4 minutes press the START button H until : is indicated on the digital display. 1 min : is indicated on the digital display . ­ Switch the appliance off ( and turn the tap off. [. . . ]