User manual SIEMENS SK76M530EU/08 INSTALLATION INSTRUCTIONS

[. . . ] 12 Switching off automatically after the end of the programme * . 12 Y Express Wash/ Speed Perfect * · Hygiene * . . 11 11 11 en Safety instructions Before you switch ON the appliance Please read the operating and installation instructions carefully. They contain important information on how to install, use and maintain the appliance. [. . . ] In the automatic programmes the temperature and running time can also be adjusted to the degree of soiling. ­ Press START button H, timer programming is activated. ­ To delete timer programming, press the 8 + or ­ button until ` : is indicated on the digital display. You can change your programme selection at any time until the programme starts. End of programme The programme has ended when the value : is indicated on the numerical display `. Switchingof automaticalyafterthe ndoftheprogram e Switching off automatically after the end of the programme * * depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). Automatic disconnection can be adjusted from : to : . Switching on the appliance ­ Turn on the tap fully. The display of the last selected programme flashes. This programme remains selected if no other programme button 0 is pressed. The expected programme duration flashes on the digital display `. The programme starts running. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display `. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). Timerprogram ing Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press button 8 + until the digital display ` jumps to : . ­ Press 8 + or ­ button until the displayed time corresponds with your requirements. The filter system consists of a coarse filter, a flat fine filter and a microfilter. ­ After each washing cycle check the filters for residue. ­ Unscrew filter cylinder as illustrated and take out filter system. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. ­ Regularly clean door seal with a damp cloth. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. [. . . ] See rating plate for required fusing 1Z. ­ The socket must be near the appliance and freely accessible following installation. If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side to satisfy the relevant safety instructions. Installation The required installation dimensions can be found in the installation instructions. Ensure that the appliance is situated securely on the floor. [. . . ]