User manual SIEMENS SN55E505EU/10 SHORT INSTRUCTIONS

[. . . ] 15 15 15 15 15 15 16 16 16 16 17 17 17 17 17 18 18 18 19 19 20 20 20 20 21 21 22 23 23 23 24 24 24 24 25 25 25 25 26 26 26 Safety instructions . Getting to know your appliance Control panel . Switching off salt refill indicator/ water softening system . Switching off rinse-aid refill indicator Utensils . [. . . ] The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). Timer programming You can delay the start of the programme in 1-hour steps up to 24 hours. Press 8 + button until the timer programming display 7 jumps to . Press 8 + or ­ button until the displayed time corresponds with your requirements. Press START button 10 , timer programming is activated. To delete timer programming, press the 8 + or ­ button until is indicated on the digital display 7 . You can change your programme selection at any time until the programme starts. Close the door. Display window Apart from information on the programme sequence, the display window 12 also indicates additional information on e. g. If you would no longer like to have this additional information displayed, proceed as follows. Hold down programme button A and press START button 10 until on is indicated. the digital display Release both buttons. The LED for button A flashes and the digital display displays the factory setting . setting Press programme button A until the factory set value is indicated on the digital display 3 . To change the setting, Press the button C to switch or off . intensive drying on Press START button 10 . Close the door. Interrupting the programme Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. To continue the programme, switch on the ON/OFF switch 1 again. Close the door. 17 en Interior light * 20 Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. The interior light comes on when the door is opened irrespective of whether the ON/OFF switch 1 is switched on or off. When the door is closed or ajar, the light is off. Hold down programme button A and press START button 10 until is indicated on the digital display. [. . . ] (This prevents residual water from running into the machine control and damaging the programme sequence). Removing the appliance Also observe the sequence of worksteps here. Disconnect the appliance from the power supply. Disconnect the waste water and fresh water connections. Loosen the fastening screws under the worktop. [. . . ]