User manual SIEMENS SN76M055EU

[. . . ] HQ 2SHUDWLQJ LQVWUXFWLRQV 6 6WDUW $ % & 5HVHW VHF en Table of contents Washing the dishes . Optical display while the programme is running . Switching off automatically after the end of the programme . Protection against frost (Emptying the appliance) . [. . . ] When the appliance has been restarted and the door closed, the light spot is lit constantly again during the rinsing phase. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press button P + until the digital display h jumps to : . ­ Press P + or ­ button until the displayed time corresponds with your requirements. ­ Press START button `, timer programming is activated. ­ To delete timer programming, press the P + or ­ button until h : is indicated on the digital display. You can change your programme selection at any time until the programme starts. End of programme The programme has ended when the value : is indicated on the numerical display h. The end of the programme is also indicated by an acoustic signal. This function can be changed as follows: ­ Open the door. ­ Hold down programme button # and press START button ` until : . . . . The LED for button # flashes and the digital display h displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display h. To change the setting, ­ Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). ­ Press START button `, the set value is saved. ­ Close the door. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display h. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 18 en The following applies to TurboSpeed 20 min. : The programme has ended when you do not want to add another rinse cycle after the light spot on the floor has flashed and you switch off the appliance with the ON/ OFF switch (. ã=Warning Switching off automatically after the end of the programme * * depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). Automatic disconnection can be adjusted from : to : . Appliance does not switch off automatically : Off after 1 min : Off after 120 min ­ Open the door. ­ Hold down programme button # and press START button ` until : . . . The LED for button # flashes and the digital display h displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display h. [. . . ] ­ The connection may be modified by technicians only. ­ A power cord extension may be purchased from customer service only. ­ Use only a residual current operated circuit-breaker which features the symbol , . Only this extension guarantees compliance with the currently valid regulations. [. . . ]