User manual SIEMENS SRVKBH6

[. . . ] 2SHUDWLQJ LQVWUXFWLRQV 'LVKZDVKHU IGV4408 9000 256 569 (9009) en Table of contents Washing the dishes . Optical display while the programme is running . Protection against frost (Emptying the appliance) . 15 15 15 15 16 16 16 16 16 17 17 17 17 18 18 18 18 19 19 20 20 20 21 21 22 23 23 23 24 24 24 24 25 25 25 25 26 26 26 Safety instructions . [. . . ] If the appliance is installed at eye-level, with flush furniture front, the light point is not visible. End of programme The programme has ended when the value is indicated on the numerical display @. The end of the programme is also indicated by an acoustic signal. This function can be changed as follows: ­ Open the door. ­ Hold down programme button 3 and switch on the main switch (. The programme button 3 flashes and the factory-set value (half-loud) lights up on the numerical display @. To change the setting: ­ Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of has been reached, the display jumps back to (off). ­ Switch off main switch (, the set value is saved. ­ Close the door. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display @. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). Timer programming * * depending on model You can delay the start of the programme in 1 hour steps up to 19 hours. ­ Press the timer programming button 8 until the digital display @ jumps to . ­ Keep pressing the timer programming button 8 until the required time is displayed. ­ To delete the preselected starting time, press the button 8 until is indicated on the digital display @. You can change your programme selection at any time until the programme starts. Switching off the appliance Short time after the end of the programme: ­ Open the door. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. 16 en ã=Warning Changing the programme After you have switched the appliance on, it is possible to change the programme within 2 min. If you want to change the programme afterwards, the appliance waits until the initiated programme section (e. The remaining time comprises the remaining time of the previous programme section and the remaining time of the new selected programme. At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme ­ Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the main switch ( again. [. . . ] ­ The appliance can easily be installed in a fitted kitchen between wooden and plastic walls. If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side to satisfy the relevant safety instructions. 24 en Electrical connection ­ Connect the appliance only to 230 V and 50 Hz alternating current via a correctly installed socket with protective conductor. See rating plate for required fusing 9*. ­ The socket must be near the appliance and freely accessible following installation. [. . . ]