User manual SIEMENS WD61392GB

[. . . ] Directions for Use GB EXTRAKLASSE 1300 Wash & Dry Contents Important information Notes on disposal Page 3 3 3 4 5 6 7 8 9 10 11 12 14 14 14 15 16 17 18 20 21 22 23 23 23 24 24 24 24 25 25 25 25 26 27 28 29 32 33 Packaging of new appliance . . Your new washer / dryer Environmental protection / notes on saving . The programme selector / the programmes . The drying time selector / The start button . [. . . ] You can select additional functions to cope with special situations. The drying time selector must be set to the position. continue with "Start", page 20. Setting the drying time programme Set the programme selector to the desired programme, e. g. The "On/Off" light illuminates. To remind you that a drying time must still be set, the "Drying Time" control light flashes. Set the drying time selector to the desired drying time. continue with "Start", page 20. Recommended drying times (minutes): Degree of dryness closet dry iron damp 2, 5 kg Cottons/ Coloureds 2 kg Easy Care 2 kg Delicates 80 70 65 65 45 45 Set shorter drying times for smaller laundry loads. To prevent overdrying of laundry which would cause it to shrink or crinkle, avoid se lecting excessively long drying times. In addi tion, overdrying would consume energy un necessarily. Note: Warm laundry appears more damp to the touch than cold laundry. This can easily lead to misjudgements. 18 Setting a wash programme Selecting a continuous washing / drying programme 1. When washing cottons/coloureds, use ma ximum loads of 2. 5 kg. Set the programme selector to the desired programme, e. g. The "On/ Off" light illuminates. Select additional functions as required. 4. Set the drying time selector to the desired drying time. Setting a drying time automatically adds a drying programme to the active wash and spin programme, taking into account the type of laundry being washed. At the start of the drying cycle, the "Delay Start / Drying" display indicates the number of minutes of drying time remaining in the programme cycle. To protect the laundry in the case of wool pro grammes, erroneously selecting a drying time will not cause a drying cycle to be added to the wash programme. When washing temperature sensitive fabrics: Press the "Higher Water Level" button. This causes the drying temperature to be lowered in the Easy Care programme (dry ing of acrylics), and the Anti Crease func tion to be switched off. 19 Starting a programme / Programme sequence Approximately two seconds after selecting the programme, the unit is ready to start. If the door is not shut properly a safety device prevents the machine from operating. Press the "Start" button. [. . . ] ­ Blocked inlet filters in water supply. ­ Blocked drain hose, drain pipe or suds pump. For cleaning the pump, see page 27. Pre Wash Anti Crease 3 Washing Anti Crease 1 If all details have been checked, set the programme selector to the Off" position. Wait 5 se conds, and proceed by again selecting and starting the initially selected programme. [. . . ]