User manual SIEMENS WXS862OE

[. . . ] Instruction Manual and Installation Instructions en SIWAMAT XS 1062 XS 862 Table of Contents Operating Instructions Safety Instructions . Before Using Your Washing Machine For the First Time . Preparing, Sorting and Loading the Laundry . Installation, Connection and Transport . [. . . ] q Turn the programme selector to Aus". q Open service flap. q Remove the drain hose from its holder and pull the hose out of the housing. q Remove the service flap. 90 °C max. q Pull down the closing cap and allow the washing lye to flow into a suitable container. 17 q Push up the closing cap (1st) and place the drain hose back in its holder (2nd). q Carefully remove the pump cap. A little more residual water will flow out. q Remove foreign objects/fluff from inside and clean the interior. The pump impeller wheel must be able to rotate. Clean any residual lye or fluff from the thread of the pump cap and pump housing. q Insert the pump cover and screw tight. To prevent unused detergent from flowing into the drain during the next wash cycle: q 1 Pour 1 litre / 1 ¾ pt of water into chamber II. q Select the b Abpumpen" programme. 18 Cleaning water inlet strainers This is necessary if very little or no water flows into the washing machine. First release the water pressure in the supply hose: q Turn off the water tap. q Turn the programme selector to any programme (except 4 Schleudern" and Q Abpumpen"). q Press the 3" button, and allow the programme to run for approx. 40 seconds. Cleaning the strainer at the water tap q Disconnect the hose from the water tap. q Rinse the strainer under flowing water. q Reconnect the hose. Cleaning the strainer on the washing machine q Disconnect the hose from the back of the washing machine. q Pull out the strainer and rinse under running water. q Insert the strainer and reconnect the hose. q Turn on the water tap and check whether water is still discharged. If water is still discharged, check that the strainer is attached properly. q Turn off the water tap. 19 Troubleshooting Minor Faults d Risk of electric shock!Repairs must only be carried out by our Customer Service or an authorized technician. If repairs are needed, and assuming that you cannot eliminate the fault yourself with the aid the following table: q Turn the programme selector to Aus". [. . . ] q Tighten the counter nut. 31 Electrical connection Caution The washing machine must only be connected to alternating current and using a properly installed socket outlet with earthing contact. The mains voltage must correspond to the voltage specification on the washing machine (nameplate). Connection specifications as well as the required fuses are stipulated on the appliance nameplate. Make sure that: - the mains plug fits the socket outlet. [. . . ]