User manual SILVERCREST CRE-521

[. . . ] English 1 Preliminary notes Thank you for selecting our MP3/WMA/OGG car radio SilverCrest CRE-521. In order for you to utilize this device and all its options, we recommend that you read the corresponding instructions in this manual before the initial use of the device, even if you’re familiar with handling electronic devices. Please pay particular attention to the chapter “Important safety instructions” on page 5. Store this manual in a safe location for future reference. [. . . ] Now please press the card that will be removed slightly into the device, until it snaps out. Afterwards you can remove the card from the slot. 28 English Note: Never use force when inserting an SD/MMC card; this could damage the device as well as the card. Also prevent direct skin contact with the contacts on the card to prevent contact problems . 15. 5 Selecting SD/MMC as a program source To play back audio tracks from an SD/MMC memory card, press the "MODE” button to select “M-CARD” as the data source. Then the device will read the music tracks that can be reproduced from the memory card and begins to play back the first track. Note: The program source “SD/MMC” can only be selected through the “MODE” button if there is an SD/MMC card in the card reader. When you remove the SD/MMC card from the device, the device automatically switches back to the most recently selected program source. 15. 6 MP3 functions Below are descriptions of the functions and displays when an MP3 CD is inserted, an MP3 player / USB storage device is connected, or when an SD/MMC memory card is inserted. When the MP3 data is read, the total amount of folders and tracks will briefly appear on the display. During the playback, the display will alternately show the folder name, track name, and the name of the artist. 15. 7 Searching for track numbers When searching for track numbers, you have the option of quickly getting to the desired track number. To start searching for track numbers, briefly press the “AS/PS” button. The message “001” will appear on the display, whereby the last digit is flashing. A maximum of three digits are available for the search. By turning the control dial you can select the last digit of the search entry and confirm it by pressing the control dial . You can also set this by turning the control dial and confirm by pressing. Proceed with the third digit in the same way. If you press the “BAND” button at the start of the search, the device selects the desired file and plays it back. If you don’t need the second and/or third digit for the search, just leave these settings unchanged and begin searching with the “Band” button . 29 Note: If a larger number is selected than there are tracks on the data storage medium, the device will start playing the last track on the data storage medium. 15. 8 Alphabetical search With an alphabetical search, you have the option of searching tracks on the storage medium according to name or parts of the name (letter entry) and thereby quickly getting the desired track. To start the alphabetical search, briefly press the “AS/PS” button twice. The message “AXX” will appear on the display, whereby the “A” is flashing. Now you can select the desired letter by turning the dial and confirming your selection by pressing it. A maximum of three letters are available for the search. After you have selected the third letter and have started the search by pressing the “BAND” button , the search will begin, along with the display of the files that match the desired track. [. . . ] The two safety screws were not removed, or not entirely. The CD was inserted with the printed side to the bottom. The CD contains incorrect or faulty data. Solution Please check if all cables have been attached correctly. [. . . ]