User manual SILVERCREST JS-101

[. . . ] Utilisation other than as described here is not permitted and it could lead to damages and injuries. This appliance fulfills, in regard to conformity with, the fundamental requirements and other relevant provisions of the EMC Directive 2004/108/EC, the Low Voltage Directive 2006/95/EC and the Ecodesign Directive 2009/125/EC (Commission Regulation 1275/2008 Annex II, No . Various countries may have different national rules on the radio frequency ranges assigned. Please note that you may not sell, transfer to third parties or abuse information received outside the assigned radio frequency ranges. [. . . ] On the left side of the radio, you will find the headphone socket. With this appliance, use only the supplied type E105 headphones. Listening to music with headphones for long periods and at high volume levels can lead to hearing damage!In order to prevent changing the settings unintentionally by touching the buttons, you can activate the key lock. With the radio switched on, press and hold the button MEM for about 3 seconds. All buttons, except the buttons SNOOZE and MEM, are now blocked. Press and hold down the MEM button again for about 3 seconds to cancel the key lock. The screen will remain lit for about 15 seconds. Fold out the base on the rear of the device to make the device more stable. When the power provision is established (mains or battery operation) the time indicated by the world receiver begins at "0:00 00" Proceed with settings the date and time, as explained in the following sections. The time functions can only be programmed when the radio is switched off. When the current date tallies with the SDA alarm, on that day an alarm sounds for 10 minutes on every hour from 8:00 - 23:00. in addition , the SDA message will flash on the screen. Turn off the alarm by pressing any button. In order to completely deactivate the date alarm set a date that is in the past!You can select which information is shown on the screen when the radio is switched off. the selected mode is indicated by a corresponding symbol on the screen. When the radio is switched off, select the display mode by repeatedly pressing the FINE button in accordance with the following table: Symbol on the screen display mode CLOCK only the time is displayed CITY the time and world time are shown in succession DATE the time and date are shown in succession CITY DATE the time, date and world time are shown in succession This multi-band radio provides you with two independently adjustable alarm times, AL1 and AL2. If the device should sound an alarm on every workday, at the weekend, the whole week or on a single specific weekday; . If the alarm should sound with an alarm tone or with the radio. You can set two alarm times in your world receiver. With the radio switched off, press the buttons VOL. [. . . ] If a station can not be found precisely the fine tuning can be use to improve reception. During the channel search press the FINE button, the screen shows FINE. This function is not available for the LW frequency range. Note: Please take note that with this the snooze function will be activated. [. . . ]