User manual SILVERCREST KH 1151 CEILING FAN

[. . . ] Only a qualified electrician may connect the appliance to a properly installed and earthed power supply with a mains voltage of 230 V~ at 50 Hz. Never submerge the appliance in liquid, never subject it to moisture and never use it outdoors. Should liquid nevertheless enter the appliance housing, disconnect the appliance from the power source, for instance by removing the associated building fuse or switching the corresponding circuit breaker (off position) in the fuse box. â· Do not kink or crush the power cable. [. . . ] First tighten both screws evenly and at the same time until hand-tight, then screw them in tightly with the screwdriver. Should you choose the short extension rod 2, proceed in the same way. During the following insertion do not damage the bolts in the extension rods 2 and the cable connection piece!Loosen the cover plate e from the covering 1, whereby you press the individual spring balls through the covering 1 and at the same time pull the cover plate e away from the covering 1. Lay the cover plate to the side for later steps in the assembly. Slide the cover 3 downwards, so that the connecting piece is concealed. Push the support upwards over the bolts, thereby ensuring that the safety screw fits into the appropriate recess. Screw the safety screw into the thread of the extension rod 2. Alternatively, determine whether the installation plate e can be fastened to the lower structure of the subceiling (wooden beam or girder) which is capable of bearing more weight, if so, use wood screws. Fix the installation plate e to the ceiling with 2 screws and, if necessary, the plugs. Use a clean cloth or cloth gloves when inserting the bulbs. Place the illumination cover 7 on the motor housing 0 then turn it clockwise until it is firmly seated. Firmly screw the blades with the 2 screws with washers, which are screwed into the blade mounts q, onto the motor housing 0 (see Fig. Hang the fan in the installation plate e, making sure that the mounting lines up properly with the notch (see Fig. Slowly turn the fan for a few complete turns in order to check that the blades are correctly installed. If the rotation is not smooth and easy, check the screw attachment of the blades. You must make certain that the electrical connection wire is not under power. Otherwise, there is the great risk of receiving an electric shock!The room ceiling and the screw connection must be capable of bearing a weight of at least 28 kg. Failure to follow these instructions presents a life-threatening risk of electric shock!Step 3: Connect the brown wire (L) (III). Adjust the speed level with the pull chain 6 on the motor housing. [. . . ] The fastening screws cannot be screwed tightly or were turned too far during installation. Replace the screws and nuts Only use screws that match the original screws; contact the manufacturer or retailer for information. The slider switch for rotation direction 5 is Place the slider switch for rotation direction 5 into the left or right position. Disconnect the fan from the mains network before checking the cable plug. [. . . ]