User manual SILVERCREST KH 1270 STEAM BRUSH

[. . . ] Otherwise, you could damage the textiles. Should care instructions not be given or known, start with the lowest temperature setting. The rating of the local power supply must tally completely with the details given on the rating plate of the appliance. To avoid possible dangers, arrange for a defective appliance to be checked and possibly repaired by qualified technicians, or contact our Customer Service Department. [. . . ] Close the water fill opening 2 to the water tank 1. ensure that the lug on the water fill opening 2 sits in the indentation on the lid. Only in this way is the water tank 1 properly closed. NEVER fill the water tank 1 with chemical substances, cleaning agents or fluids other than mains water (or a mix of mains and distilled water) . The water tank 1 must audibly engage with the unlocking device for the water tank 4. To release the first steam blast after heating the appliance up, it can happen that you may need to press the steam blast button 8 several times in succession. To use the steam and brush function, place the brush attachment w onto the steam brush. To do this, slide the brush attachment w all the way along the guide to the end. To be able to use the ironing function, remove the brush attachment w from the steam brush. To do this, press the unlocking device q downwards and, at the same time, pull the brush attachment w away to the front. The steam brush can be used with all clothing items. caution is to be exercised with heat-sensitive materials such as synthetics , polyamides or artificial silk. With these materials you should first check at a concealed part (inside seam) that the hot steam will not cause any damage to the garment. Do not touch these materials directly with the hot sole of the iron 0. Suspend the crumpled garment from a coat hanger. With one hand pull the garment flat, then steam it from top to bottom. Use light pressure with the clothes brush r and guide the appliance from top to bottom over the garment. You can thereby press the steam blast button 8 in short intervals. This must engage audibly with the unlocking device on the brush attachment q. Insert the power plug 7 into a correctly installed and earthed mains power socket. As soon as the set temperature has been reached, the heating-up control lamp 5 goes out. You can repeatedly press the steam blast button 8 until the heating-up control lamp 5 glows or water drips from the sole of the iron 0. [. . . ] This appliance has been manufactured with care and meticulously examined before delivery. Please retain your receipt as proof of purchase date. Should a claim need to be made under the warranty, please make contact by telephone with our service department. Only in this way can a post-free despatch for your goods be assured. [. . . ]