User manual SILVERCREST KH 2029 MULTI-BAND RADIO

[. . . ] Intended use Technical Data Symbols used Safety information Operating elements Starting up General functions Time functions Before using the device for the first time, read these operating instructions carefully and keep them for later reference. Hand the instructions over when transferring the device to a third party. Every copying, also as extracts, as well as any reproduction of images, even in an altered state, is only permitted with the written consent of the manufacturer. This device is designed to receive generally approved radio transmissions in all countries (world receiver) and only for domestic use. [. . . ] If an RDS signal is not received at the first switch-on, the pre-adjusted time for the multi-band radio begins with "0:00 00". If the device is disconnected from its power supply the settings are lost. In addition, you can check and adjust the world time, the date alarm, medium wave reception, the alarm time interruption and the hour mode as well as switch the automatic update on or off. When you press the button MODE with the radio switched off, the function to be programmed blinks for about 15 seconds. During this time, adjust the setting with the UP/DOWN buttons. Press MODE x 9: Switch automatic update on/off To apply a setting, just wait until the screen stops flashing (the screen reverts to the time indication) or press MODE to move on to the next function. Press the UP or DOWN button to move the time forward or backward at minute intervals. Hold down one of the buttons for a few seconds to move the setting forward or backward quickly at 10 minute intervals. If summer time is required, this can be set when setting the time zone. Press the UP or DOWN button to move the date forward or backward. Keep either of these buttons pressed for a few seconds to change the date in ten-day steps. Press the UP or DOWN button to move the time zone forward or backward. -10:00 -9:00 -8:00 -8:00 -7:00 -6:00 -6:00 -5:00 -5:00 -5:00 -4:00 -3:00 -3:00 0:00 0:00 1:00 1:00 1:00 1:00 2:00 2:00 3:00 3:00 4:00 5:00 6:00 7:00 8:00 8:00 8:00 9:00 10:00 11:00 12:00 no yes yes yes yes yes no yes yes yes no no no yes yes yes yes yes yes no yes yes no no yes yes no no no no no yes no yes UTC is the reference for the times of the various time zones around the world. Not every time zone around the world differentiates between summer and winter time. To display your timezone correctly you must, subject to the actual time zone, activate or deactivate the Summer Time offset. The screen shows the SUN OFF message when summer time has been deactivated. Summer time offset is now activated and the clock moves one hour ahead. Press MODE again or four times to show the world time. Press the UP or DOWN button to move the time zone forward or backward. To properly show your programmed world time, you must activate or deactivate the Summer Time offset for each world time. Press the UP or DOWN button to set the date on which the alarm should sound. Press the SNOOZE button to ignore the year number setting so that the alarm sounds every year. [. . . ] Never use petrol, solvent or detergents that could attack the plastic!Dispose of the device using an authorised disposal company or your local disposal facility. This device is subject to European Directive 2002/96/EC. please follow the currently valid regulations. [. . . ]