User manual SILVERCREST KH 2030 MULTI-BAND RADIO

[. . . ] Time, date, time zone and world time Select display mode Alarm function Stop watch function Countdown function Before using the device for the first time, read these operating instructions carefully and keep them for later reference. Hand the instructions over when transferring the device to a third party. This device is designed to receive generally approved radio transmissions in all countries (world receiver) and only for domestic use. It has not been designed to receive transmissions that are not generally approved, nor as part of safety radio systems, e. [. . . ] During this time, adjust the setting with the UP/DOWN buttons. To apply a setting, just wait until the screen stops flashing (the screen reverts to the time indication) or press MODE to move on to the next function. Press the UP or DOWN button to move the time forward or backward at minute intervals. Hold down one of the buttons for a few seconds to move the setting forward or backward quickly at 10 minute intervals. If summer time is required, this can be set when setting the time zone. Press the UP or DOWN button to move the date forward or backward. Keep either of these buttons pressed for a few seconds to change the date in ten-day steps. Press the UP or DOWN button to move the time zone forward or backward. UTC is the reference for the times of the various time zones around the world. The screen shows the SUN OFF message when summer time has been deactivated. Summer time offset is now activated and the clock moves one hour ahead. Press MODE again or four times to show the world time. the city abbreviation appears with the corresponding time. Press the UP or DOWN button to move the time zone forward or backward. Press the UP or DOWN button to set the date on which the alarm should sound. Press the SNOOZE button to ignore the year number setting so that the alarm sounds every year. If the current date is the same as the SDA date, an alarm sounds every hour from 8 o'clock on this day. in addition , the SDA message will flash on the screen. Turn off the alarm by pressing any button. In order to completely deactivate the date alarm set a date that is in the past!You can select which information is shown on the screen when the radio is switched off. the selected mode is indicated by a corresponding symbol on the screen. [. . . ] Select LX for strong stations and DX to improve reception for weak stations. the telescopic aerial does not work in the MW and LW bands. In these bands, the radio uses its built-in ferrite aerial. This device is subject to European Directive 2002/96/EC. [. . . ]