User manual SILVERCREST KH 2131 RADIO SET

[. . . ] Risks can be generated by the device if it used for unintended purposes and/ or other types of use. Claims of any kind resulting from damage caused by improper use, incompetent repairs, unauthorized modifications or the use of non-approved spare parts are excluded. In the existing operation instructions the following warnings are used: DANGER A warning at this danger level indicates a threateningly dangerous situation. If the dangerous situation is not avoided, it could result in death or serious injury. [. . . ] For the safe and error-free operation of the device, the installation location must fulfill the following conditions: Place the device on a firm, flat and level surface. Do not locate the device in a hot, wet or very humid environment or close to flammable material. The surfaces of furniture may contain components that could attack and weaken the rubber pads of the device. if necessary , place an anti-slip mat or similar under the rubber pads of the device. The mains power socket must at all times be easily accessible, so that the power adapter can be easily and quickly removed if necessary. Before connecting up, compare the connection data (voltage and frequency) on the type plate of the device with that of your power supply network. This data must tally in order to avoid damage to the device. Check to ensure that the power cable of the device is undamaged and that it will not be laid over hot surfaces and/or sharp edges. Ensure that the power cable is not over taut or crimped/folded. Do not let the power cable hang over edges (trip wire effect). NOTICE It is recommended that, in addition to switching the radio transmission set off, you disconnect the power adapter from the mains power supply or use switchable power strips. Only in this way can it be ensured that the device is fully switched off and a contribution made to the economical use of power. In this chapter you receive important information for the handling and operation of the device. If the signal source makes the output signals available to you via a Scart output, use also the Scart to cinchplug adapter OUT (Transmitter) 24 . If need be, you can connect a second signal source to the transmitter. NOTICE If, despite an occupied A/V output, you wish to additionally connect the used signal source to a TV, connect the TV with the transmitter via the socket TO TV 7 . To do this, use either one of the supplied cinchplug jackplug cables 22 , or an identical cable from a dealer (see Figure Connection example transmitter). The transmitting diode should be affixed immediately adjacent to the IR receiving diode on your device (see Fig. Connect one of the power adapters to the DC IN 10 socket of the transmitter and then plug it into a properly installed mains power socket. For this, use the supplied Cinch to Cinch cable 27 . If the target device has a Scart input, use additionally the Scart - Cinch adapter IN (Receiver) 23. Connect one of the power adapters to the DC IN 20 socket of the receiver and then plug it into a properly installed mains power socket. [. . . ] The warranty period is not extended by repairs effected under warranty. this applies also to replaced and repaired parts. Damages or defects discovered after purchase are to be reported directly after unpacking, at the latest two days after the purchase date. Repairs carried out after the lapse of the warranty period are subject to charge. [. . . ]