User manual SILVERCREST KH 2155 UNIVERSAL REMOTE CONTROL

[. . . ] Index Important safety instructions Device overview First use Inserting the batteries Operating elements LCD display Buttons Configuration Setting the time Adjust contrast Background Illumination Child protection system SETUP - System settings Programming the remote control Programming by brand code search Programming by manual code input Programming by automatic code search Learn function Code learn function Clear programmed button Programming Macros Favourites channel Volume control Vol +/--, (Mute switching) Further volume control functions (except PC) Back to volume control Additional functions All OFF Automatic station redirecting Alternative button allocation in teletext mode Alternative button allocation in PIP mode Faults / Remedies Disposal CE- Conformity Importer Technical data Important Warranty Notices -1- Page 2 3 4 4 5 5 6 9 9 9 10 10 10 12 12 13 14 15 16 17 18 20 22 22 22 22 23 23 24 24 25 25 26 27 27 27 27 Unpacking the device / checking the package contents 4 Universal remote control KH2155 Read the operating instructions carefully before using the deviceforthefirsttimeandpreservethisbookletforlater reference. Hand over the instruction manual to whomsoever you might pass the device on to. Important safety instructions Proper use Children may only operate the remote control under adult supervision. The universal remote control can replace a maximum of eight remote controls. It can only be used for entertainment electronics with infrared receivers. [. . . ] If in the LCD display q is shown "WAITING" then stopping can only be carried out with the EXIT j button. After which the URC again returns to the "LEARN KEY" mode (see step 4). - 16 - Clear programmed button 1. Hold down the SET button e for a little longer than 3 seconds. With the or button h select "LEARNING" and confirmwiththeOKbuttonl. In the LCD display q appears "LEARN KEY". With the or button h select "DELETE KEY" and confirmwiththeOKbuttonl. In the LCD display q appears "SELECT KEY". Press the taught button that is to be deleted. In the LCD display q appears "SURE DELET" (are you sure?). ConfirmthedeleteprocesswiththeOKbuttonl. In the LCD display q appears "DELETED" and then again "SELECT KEY". Repeat steps 5-6 to delete further buttons. Press any device button r to end the mode. Delete all of a device's programmed buttons 1. Hold down the SET button e for a little longer than 3 seconds. With the or button h select "LEARNING" and confirmwiththeOKbuttonl. In the LCD display q appears "LEARN KEY". With the or button h select "DELETE DEV" (delete device)andconfirmwiththeOKbuttonl. In the LCD display q appears "SELECT DEV" (select device). Select the device button r for the device whose taught button command you want to delete. In the LCD display qappears"SUREDELET". Confirm with the OK button l. In the LCD display q appears "DELETED" and then "SELECT DEV". [. . . ] Search for a code that supports more of the target device's functions. The remote control stops reacting after a button is pressed. > The batteries must have enough voltage and be properly installed. > Point the remote control towards your device. [. . . ]