User manual SILVERCREST KH 2289 KITCHEN RADIO

[. . . ] Technical data Intended Usage Safety information Items supplied Legend Fixing the kitchen radio beneath a wall cabinet Setting up the kitchen radio Commissioning Read the operating instructions carefully before using the appliance for the first time and preserve this booklet for later reference. This appliance has been both examined and approved in regard to conformity with the fundamental requirements and other relevant regulations of the EMC Directive 2004/108/EC as well as the Directive for Low Voltage Appliances 2006/95/EC. The Kitchen Radio is intended for use either freestanding or for assembly beneath a wall cabinet. The intended uses for the Kitchen Radio are the reception of FM radio transmissions and as an alarm/timer, using signal tones or the radio itself. [. . . ] Press the kitchen radio up until you hear it engage. Do not set up the kitchen radio without the mounting plate q. Otherwise the speakers are covered and the sound is scarcely audible. To set up the kitchen radio with the enclosed mounting plate q: 1. Simultaneously press the two retaining levers on the back of the appliance down. Push the mounting plate q back and remove it. Push the two retainer lugs on the mounting plate q into the recesses on the lower rear side of the kitchen radio. Firmly press the front part of the mounting plate q down until you hear it engage. To disassemble the mounting plate q, grip the mounting plate q from below with the thumbs and press it forwards and up until it disengages. You can now remove the mounting plate q. Secure the wire antenna with a piece of adhesive tape such that it does not hang down. To disassemble the kitchen radio, press the two retaining levers at the rear of the appliance downwards. Then pull the kitchen radio forewards to remove it. Replace the mounting plate onto the radio as described in the following section. The back-up batteries ensure that the programmed time, date, alarm time and set SDAs (Special Day Alert) are not erased in the event of a power failure. They are not supplied with the appliance. Pressing and holding the buttons changes the date at intervals of 10 days. If a button is not pressed within 10 seconds, the kitchen radio defaults back to automatic mode. The kitchen radio then reminds you at 8 a. Pressing and holding the buttons changes the date at intervals of 10 days. When you deactivate the year, the SDA alarm will respond on the set date every year. If a button is not pressed within 10 seconds, the kitchen radio defaults back to automatic mode. [. . . ] Press the button ALARM MODE o repeatedly until the desired alarm days are programmed in. Keep the button ALARM MODE o pressed down until a single day appears on the display. To return to the selection of workdays, weekends or whole weeks, once again hold the button ALARM MODE o briefly pressed down. Press the button MODE SETTING i to save the settings and to return to automatic mode. [. . . ]