User manual SILVERCREST KH 2305 MICRO STEREO SYSTEM

[. . . ] Intended use Items supplied Technical Data Safety information Setting the device The operational controls Inserting the batteries Handling of batteries Becoming acquainted with the remote control Connecting the components Switching the device on and off Selecting the programme source Setting the volume Using headphones The Bass Boost function Operating the radio Operating the CD player MP3 functions Playback of USB memory devices Operating the cassette player/recorder Cleaning and care Troubleshooting Disposal CE Conformity Importer Important warranty Notices Read the operating instructions carefully before using the device for the first time and preserve this manual for later reference. Pass this manual on to whoever might acquire the device at a future date. This micro system is intended exclusively for the playback of audio CDs, MP3-CDs, CD-R, CD-RW, USB flash memory mediums, audio cassettes and for the playback of radio programmes. additionally , the micro system is suitable for the recording of audio cassettes. [. . . ] When CD playback is stopped the playback symbol 4 blinks in the display y. Search forward and backward You can activate a search to look for specific passages within a title. > For this, during playback, hold down the button : i and/ or SKIP + 3( (forwards) or the button 9 o and/or SKIP -- 4# (backwards) until the desired location in the title is reached. stopping the play function > Press the button < 2#on the device and/or STOP < 3* on the remote control. Removing the CD > To open the CD tray q carefully press on the " " marked spot w of the CD tray lid. > To close the CD tray q push the lid, by hand, downwards and carefully press on the " " marked spot w until the lid locks into place. Switching on the repeat function With the repeat function you can repeat play individual titles or all the titles of a CD. When you want to emphasize the deep frequencies during playback press the BASS BOOST r button. This device receives radio stations on the frequency bands, Ultra short wave (USW or engl. In some countries, different national regulations may apply to the assigned radio frequency ranges. Please note that information received outside of the assigned radio frequency ranges may not be used, passed on to third parties or otherwise misused. > In order to receive a good USW reception with the micro system unwind the dipole antenna 3) on the rear panel of the device completely. > If the reception is insufficient change the position of the dipole antenna 3). Secure the dipole antenna 3), if necessary, with sticky tape. > The device has a built in ferrite antenna for reception of MW stations. When the MW reception is insufficient please turn the device in a more favourable direction. > To activate the radio function move the FUNCTION switch 2@ to the "RADIO" position. > Now select with the BAND switch 1) the desired frequency band FM or AM depending on which band the station that you want to hear is located. if the switch is in the position FM ST , the appliance plays the VHF station in stereo. > With the aid of the TUNING controller u you can now select the station. For this turn the controller in a clockwise direction to select stations with a higher broadcast frequency than the one currently shown in the display y. Playing MP3 titles > Place a CD with MP3 files into the CD tray q. [. . . ] This device has been both examined and approved in regard to conformity with the fundamental requirements and other relevant regulations of the EMC Directive 2004/108/EC and the low voltage directive (LVD) 2006/95/EC. The warranty for this device is for 3 years from the date of purchase. Should you, in spite of our high quality standards, have grounds for complaint please contact our Service Hotline. In the event that processing of your complaint is not possible by telephone here you will receive · A processing number (RMA number) as well as · An address to which you can send your device for repair under warranty. [. . . ]