User manual SILVERCREST KH 2321 RETRO WOODEN RADIO

[. . . ] In a case of danger, the plug must be quickly and easily accessible. You may not open the casing or repair the appliance yourself. Should you do so, appliance-safety can no longer be assured and the warranty becomes void. Repairs are to be carried out exclusively by a specialist firm or the service centre. · Technical data Mains voltage: Power failure safeguard: 230 V AC / 50 Hz 1x1, 5V battery Type AA (Not supplied) 15 W 530 ­ 1600 KHz 87. 5 - 108 MHZ Alarm tone +5°. . . [. . . ] Insert the power plug into the power socket. Select a wall socket that will at all times be easily accessible, so that the plug can be easily withdraw in the event of a malfunction. Notice: Rechargable batteries cannot be charged via the battery connection. -5- SilverCrest KH 2321 Setting the clock When you first take the appliance into use after inserting the battery: To set the time, press the rotating switch CLOCK SET in and turn it until the correct time is shown in the display. When done, pull the rotating switch CLOCK SET back out. Notice: The analoge clock only functions with an inserted battery. Radio Reception Turn the rotating switch to the position FM or AM. Turn the volume adjuster VOLUME to a central position. Now tune in to the desired radio station, by turning the TUNING adjuster . NOTE: To improve the reception of radio stations transmitting in FM frequencies, move the end of the wire aerial slowly in various directions. When you have found the best reception from the desired transmitter, fix the wire aerial into this position e. g. An aerial is built into the appliance for the reception of AM transmitters . For improved reception, alter the actual position of the appliance in radio operation. Clockface illumination The clockface illumination can be switched on and off with the switch CLOCK LIGHT ON / OFF . Adjusting the alarm timings External audio sources If the clock is set correctly, as described above: Adjust the alarm time by turning the rotating switch ALARM SET . You can connect external audio sources to this appliance with a 3, 5 mm jack plug. · Connect the audio output of the external audio source to the AUX IN connection with a 3, 5 mm jack plug. · Adjust the rotary switch to the position AUX. · The signals from the external audio source will now be reproduced over the loudspeakers. Switching the alarm on and off The alarm is activated when the button ALARM ON/OFF is in a raised position. To deactivate the alarm, press the button ALARM ON/OFF back down. -6- SilverCrest KH 2321 Using headphones You can connect headphones to the appliance with a 3, 5 mm jack plug. The headphone connection socket is located at the rear of the appliance. When headphones are connected, the loudspeakers are deactivated and sounds can only be heard over the headphones. Disposal Do not dispose of the appliance in your normal domestic waste. Dispose of the appliance through an a pproved disposal centre or at your community waste facility. Observe the currently applicable regulations. [. . . ] Products sent in without the RMA number cannot be processed. Note: Warranty claims are only valid for material or manufacturing defects. Warranty claims are not valid · for parts subject to wear and tear. · for damage to breakable parts such as switches and batteries. [. . . ]