User manual SILVERCREST KH 2322 RETRO WOODEN RADIO

[. . . ] In cases of danger, the plug must be quickly and easily accessible. You may not open the casing or repair the appliance yourself. Should you do so, appliance safety can no longer be assured and the warranty will become void. Repairs are to be carried out exclusively by a specialist firm or the service centre. · · Technical data Mains voltage: Batteries : 230 V AC / 50 Hz 2x1, 5V Mignon (R6 / LR6 / AA) (Not supplied) 15 W 530 ­ 1600 KHz 87. 5 - 108 MHZ Radio, alarm signal +5°. . . [. . . ] Select the desired wavelength (FM/AM) with the Waveband selector . Now tune in to the desired radio station, by turning the TUNING adjuster . NOTE: To improve the reception of radio stations transmitting in FM frequencies, move the end of the wire aerial slowly in various directions. When you have found the best reception from the desired transmitter, fix the wire aerial into this position e. g. An aerial is built into the appliance for the reception of AM transmitters . For improved reception, alter the actual position of the appliance in radio operation. Setting the clock When you first take the appliance into use, or the time must be adjusted, proceed as follows: NOTE: The time and alarm settings can be made without the insertion of batteries, however, the appliance then needs to be connected to mains power. The power failure protection is not in effect. Whilst you hold the button TIME pressed down: Press several times in succession, or simply hold down, the button HOUR to adjust the hours. Release the button HOUR when the desired hour setting is shown in the Display . -6- SilverCrest KH 2322 Adjusting Alarm Settings If the clock is set correctly, as described above: NOTE: The time and alarm settings can be made without the insertion of batteries, however, the appliance then needs to be connected to mains power. The power failure protection is not in effect. SET : Press several times in succession, or simply hold down, the button HOUR to adjust the hours. Release the button HOUR when the desired hour setting is shown in the Display . Press several times in succession, or simply hold down, the button MINUTE , to adjust the minutes. Release the button MINUTE when the desired hour setting is shown in the Display . The adjusted alarm time is automatically taken over as soon as the button AL. SET is released. You will be awakened by the radio if . . . the volume adjuster VOLUME is set at a volume level that will wake you. You will be awakened by the signal tone if. . . the volume adjuster VOLUME is turned so far down that it has switched itself off with an audible click, i. e. it is in the position BUZZ. Switching the Alarm OFF Press the button SNOOZE , and the alarm will repeat itself after 5 minutes. ON/OFF to activate the alarm function for the next day. In the Display ALARM is still to be seen. [. . . ] Note: Warranty claims are only valid for material or manufacturing defects . Warranty claims are not valid · for parts subject to wear and tear. · for damages to breakable parts such as switches and batteries. This product is intended solely for private use, not for commercial applications. [. . . ]