User manual SILVERCREST KH 2600 WAKE-UP LIGHT

[. . . ] 15 Playback music from an iPod/iPhone 17 Playback of external audio devices 19 Playback of nature sounds . These operating instructions are a component of the KH 2600 Wake-Up Light (henceforth designated as the device) and they supply you with important information about the intended use, safety and connection as well as operation of the device . The operating instructions must be constantly kept available close to the device. They are to be read and applied by everyone assigned to operate and troubleshoot the device. [. . . ] NOTICE The /ALARM OFFbutton 20 does not completely disconnect the device from the mains power. To completely disconnect the device from the mains power the mains power cable plug 23 must be pulled from the mains socket. 2 seconds to switch between the 12h/24h time of day display. Set, with the I button 11 or the I button 13 , the current time of day hour. With each button press the time changes by one hour. Holding down the respective button for more than 2 seconds starts the speed setting. Set, with the I button 11 or the I button 13 , the current time of day minutes. With each button press the time changes by one minute. Holding down the respective button for more than 2 seconds starts the speed setting. NOTICE The time of day will revert back to 0:00 o'clock if the device is disconnected from the mains power supply with no back-up batteries inserted or if the back-up batteries are too weak. The set volume level is shown below and to the right in the display 4 . nOTICE The set volume applies for all functions. The volume you have selected will also be saved automatically as the volume for the wake function. NOTICE For a good radio reception the wire antenna 24 must be completely uncoiled. Press and hold down the I button 11 or I button 13 for at least two seconds. Press the ALARM1/ALARM2 button or the MEM-/MEM+ button on the remote control to select the desired memory slot between 01 and 20. Press the MEMORY/TIME button 17 or the MEM button on the remote control again to save the reception frequency of the set station to the selected memory slot. nOTICE If no input is made within approx. 5 seconds after the MEMORY/TIME button or the MEM button on the remote control is pressed the "MEMORY 01" indicator in the display goes out and the current station is not saved. Connect an external audio device, for example, an MP3 player to the 3. Button 12 several times to select the nature sounds function . Select with the I button 11 or the I button 13 between the following 4 nature sounds: Rain Babbling brook Seagulls Rural life The LEDs light up in the following sequence: blue red red + blue green green + blue red + green all LEDs etc. [. . . ] The following table will help with localizing and remedying minor malfunctions: Defect The display is showing nothing. possible cause The plug is not inserted. Mains power socket is not supplying power. Solution Insert the plug into the mains power socket. [. . . ]