User manual SILVERCREST KH 4421 HANDHELD VACUUM CLEANER

[. . . ] Manipulations made by persons other than qualified technicians could represent a health hazard. · Before switching the hand vacuum cleaner on, make certain that the mains voltage corresponds to the voltage indicated in the technical data for the appliance. · Never touch the power supply or the appliance with wet or damp hands. · Do not use the power adapter with an extension cord; connect the power adapter directly to a power socket. [. . . ] Never carry the charging station or the power adapter by the cable. Do not pull on the cable when you want to move the appliance. · Always grip the power plug to disconnect the appliance from the power supply. Charging NOTE: Make certain that the on/off switch 5 is in position "0" before starting the charging process. Insert the round plug of the power supply into the back of the charging station 7. Lock the plug by turning it anti-clockwise. -3- 2. Place the charging station 7 next to a power socket and plug the power adapter in. The charging station can optionally be mounted on a wall with the supplied screws and plugs i (see Chapter , , Mounting the wall bracket"). Vertical screw spacing 102 mm, screw diameter 3, 5 mm. The borehole has to fit for plug diameter 5 mm. You can store the crevice tool and the upholstery brush in the slots on the charging station 7. Place the hand vacuum cleaner in the charging station 7. The charge indicator light 6 lights up red and the charging process begins. Mounting the Wall Bracket 1. Using the wall bracket 7 to mark the boreholes ensures the correct spacing. Push the plugs 8 into the boreholes and screw in the lower screw 8 until ca. Place the wall bracket 7 on the lower screw. Guide the upper screw 8 through the wall brakket 7 and into the borehole, then screw it in. Tighten both screws 8 down. Assembly NOTE: Make certain that the dust filter 3 is always inserted before using the appliance. To open the dust collector 2, turn the dust collector 2 and pull it off the motor unit 4. Make certain that the dust filter 3 is inserted and put the dust collector 2 back on. Turn the dust collector 2 until the arrow symbol points to the dot on the motor unit 4. Should the crevice tool or the upholstery brush be required, insert them into the suction opening of the dust collector 2. Important: · Once the charging process is completed, the appliance automatically switches to the charge maintenance function. However, in order to avoid possible damage to the batteries, do not leave the appliance constantly connected to the charging station . · Only place the appliance back on the charging station u once the vacuum power becomes noticeably weaker. Important information about the battery In the event of a defective battery, please contact our service centre directly. [. . . ] Please retain your receipt as proof of purchase date. Should a claim need to be made under the warranty, please make contact by telephone with our service department. Only in this way can a post-free despatch for your goods be assured. The warranty covers ONLY claims for material and maufacturing defects, not for wearing or consumable or for damage to fragile components. [. . . ]