User manual SILVERCREST KH 4423 CORDLESS HAND-HELD VACUUM CLEANER

[. . . ] This appliance is not suitable for use with inflammable and explosive substances or chemical and aggressive liquids. To prevent accidents, keep the appliance in a dry location when not in use. In the event that battery fluid comes into contact with skin or eyes, the affected area must be rinsed off with water immediately. Do not charge or use the appliance outdoors. [. . . ] For care of the batteries we recommend the following: after the batteries are charged, remove the power adapter 4 from the mains power socket. Reconnect the power adapter 4 again with the mains power socket when the suction power of the appliance is noticeably weaker. Select a suitable installation location for the wall holder 3: It should present no problem with taking the hand vacuum cleaner out of it and a mains power socket for the power adapter 4 must be accessible. Bore two holes with a spacing of approx. Use the wall holder 3 to mark the boreholes: this will ensure the spacing is correct. Insert the wallplugs into the boreholes and, using the screws, firmly screw the wall holder 3 to the wall. Connect the power adapter 4 to a mains power socket. Check to ensure that the on/off switch 6 has been slid back (to the position "0") before starting the charging process. Place the hand vacuum cleaner from above into the wall holder 3 so that the barrel plug 5 slips into the socket on the hand vacuum cleaner. Make certain that the dust filter 9 is always inserted before using the appliance. Only vacuum up enough fluid/rubbish until the dirt container 0 is filled to the MAX marking. Take the hand vacuum cleaner from the wall holder 3 or, if you do not use the wall holder 3, remove the barrel plug 5 from the socket. The crevice nozzle 2, to clean narrow and difficult to reach locations. When the charging process is complete, which may take 12 to 15 hours for completely discharged batteries, the device switches over to a trickle charge (maintenance function) automatically. Nevertheless, in order to avoid possible damage to the batteries, do not leave the appliance permanently connected to the power adapter 4. Reconnect the appliance with the power adapter 4 when the suction power has become noticeably weaker. After you have vacuumed up liquids, immediately clean the dirt container 0. Otherwise bacteria and microbes could form in it!When you have finished using it, slide the on/ off switch 6 to the rear. Place the hand vacuum in the wall holder 3 and start the charging process when the vacuum power has become noticeably weaker. The hand vacuum cleaner can also be charged directly via the power adapter 4. For this, remove the barrel plug 5 with a slight twist from the wall holder 3 and insert it into the socket on the hand vacuum cleaner. [. . . ] In the event of misuse and improper handling, use of force and interference not carried out by our authorized service branch, the warranty will become void. Your statutory rights are not restricted in any way by this warranty. The warranty period will not be extended because of a repair made under warranty. this applies also to replaced and repaired parts. [. . . ]