User manual SILVERCREST KH 5540 MEN´S SHAVER

[. . . ] Men`s Shaver Protective cap Cleaning brush Storage case Operating instructions Order card After the unpacking, remove all wrapping materials and protective foils from the appliance. 1 Cutting heads 2 Cutting unit 3 Release button 4 Locking button 5 On/Off switch 6 Battery charge indicator 7 Socket 8 Storage case 9 Brush 0 Mains power adapter q Connector plug w Long-hair trimmer e Switch for the long-hair trimmer r Protective cap Do not recharge the battery after every use. Only recharge the battery when the lowest lamp on the battery charge indicator 6 blinks. Shaving using the power adapter 1000 mA Should you wish to use the Men`s Shaver without first charging the battery, you can do so by using energy directly from the mains power adapter 0: 1. [. . . ] Always remove the mains power plug before cleaning the appliance!Otherwise, there is the great risk of receiving an electric shock!Do not use abrasive, chemical or caustic cleaning agents to clean this appliance. Before changing the cutters 2 ALWAYS disconnect the mains power plug!Otherwise, there is the great risk of receiving an electric shock!You must run the Men`s Shaver over the same spot several times to obtain an acceptable result, . New cutters can be obtained with the enclosed order form. Clean the cutting heads 1 with the brush 9 after every shave. Press the release button 3, so that the cutting unit 2 springs up. Carefully tap the cutting unit 2 on a smooth surface or blow the hair trimmings away. Use the brush to remove the remaining hair trimmings. The cutting unit 2 is suitable for cleaning under running water. Press the release button 3, so that the cutting unit 2 springs up. Hold the cutting unit 2 under the flow of water so that the water runs from the inside to the outside, through the cutting heads 1. Ensure that you hold ONLY the cutting unit 2 under the flow of water!The hand element of this Men`s Shaver is protected only against spray water, it could be irreparably damaged if it is held under running water. Allow the cutting unit 2 to dry out completely before using the Men`s Shaver again. Extend the cutting unit 2 a little, so that it allows itself to be pulled upwards. Press the pin marked with arrows in the middle of the cutters 2 down a little. Carefully turn it the direction of the arrows until the mounting of the cutters allows itself to be lifted (see illustration). Clean all parts under running water and then allow them to dry completely. To secure it, press the pin marked with arrows in the middle of the cutters 2 down and then turn it in the direction of the arrows until the mounting of the cutters no longer allows itself to be lifted. [. . . ] This product is for private use only and is not intended for commercial applications. In the event of misuse and improper handling, use of force and interference not carried out by our authorized service branch, the warranty will become void. Your statutory rights are not restricted in any way by this warranty. Used batteries/cells may not be disposed of in household waste. [. . . ]