User manual SILVERCREST KH 6502 DVD-PLAYER/RADIO

[. . . ] Technical Data Applications and functions Package contents Operating elements Setting up of the DVD player Safety instructions Inserting batteries into the remote control and DVD player Connecting to a television via the video output (Composite Video) Connecting audio components to the DVD player Operation Radio functions DVD player functions Setup menu in DVD mode 13. Display disc information Accessing the DVD menu Playback Control (PBC) with VCDs/S-VCDs Superimpose and fade out subtitles (DVDs/VCDs/S-VCDs only) Changing playback language (DVDs/VCDs/S-VCDs only) Programme function Read these operating instructions carefully before using the appliance for the first time and preserve this manual for later reference. Pass this manual on to whoever might acquire the appliance at a future date. This device has been tested and approved in accordance with the basic requirements and other relevent regulations of the EMC guidelines 2004/108/EG as well as the guidelines for low voltage appliances 2006/95/EG. [. . . ] The DVD player supports USB memory sticks 1. USB memory sticks must be inserted into the USB port. Open the disc tray on the front panel of the DVD player by pressing the button "Open/Close" on the front panel of the DVD player or on the remote control. Press the OPEN/CLOSE button on the front panel of the DVD player or on the remote control again to close the disc tray. Close shows in the display while the disc tray is closing. This procedure also applies to particular memory cards. ⷠThe contents of the inserted DVD/VCD/S-VCD will now be loaded; this may take a few seconds. If the memory card or USB memory stick does not contain any playable data the memory card and/or USB function is not selectable. DVDs, VCDs and S-VCDs, that you want to playback with the DVD player possibly have a country code, which is printed on the DVD cover. The DVD player can only playback DVDs/VCDs/S-VCDs with the country code 2. If no country code is printed on the cover of a DVD/VCD/S-VCD. ⷠBut instead the symbol , then the DVD/VCD/S-VCD can be played back with the DVD player · Then the DVD/VCD/S-VCD can possibly not be played back with the DVD player. You can check this by attempting to play back the DVD. Depending on the inserted DVD/VCD/S-VCD it is possible that the contents of the DVD/VCD/s-VCD will not playback immediately, rather first a selection menu appears in the display. In this event select the menu option which will start the playback of the film with the control button on the remote control. 3 Removing memory cards/USB memory sticks Memory cards/USB Memory sticks should only be removed after the memory card/USB slot is deactivated. Press the USB/CARD button on the remote control several times or the USB/SD/MMC CARD button on the device until the message DVD appears in the display to return to the DVD mode. ⷠYou can now remove the memory card/USB memory stick from the memory card/USB slot. Depending on the inserted disc it is possible that the contents do not immediately play back, but first a selection menu appears in the display. ⷠIn this case select with the control buttons the menu item, which starts playback of the film. If you attempt to carry out functions that are not available the message "INVALID KEY" appears in the display. ⷠWith the buttons SKIP DOWN/SKIP UP you can skip, during playback, within the film on the inserted DVD/VCD/S-VCD backwards to the previous chapter/ title or to the start of the next chapter/title. [. . . ] Contact one of our service partners in your area if . Video signal or FBAS signal; thereby it involves an image signal, in which colour and brightness information are included at the same time. PAL is the mid and west Europe (Exception: France, see the heading "SECAM") customary and most wide spread colour television standard. NTSC is a colour television standard that is primarily used in the USA and Japan. [. . . ]