User manual SILVERCREST KH 2031

[. . . ] Intended use Technical Data Symbols used Safety information Operating elements Starting up General functions Time functions Before using the device for the first time, read these operating instructions carefully and keep them for later reference. Hand the instructions over when transferring the device to a third party. This device is designed to receive generally approved radio transmissions in all countries (world receiver) and only for domestic use. It has not been designed to receive transmissions that are not generally approved, nor as part of safety radio systems, e. [. . . ] Fold out the base on the rear of the device to make the device more stable. The time functions can only be set when the radio is switched off. When used for the first time the preset time of the global receiver is set to "0:00 00". If the device is disconnected from its power supply the settings are lost. You can also query and set the world time, data alarm, medium wave reception, alarm time reception and hourly mode. When you press the button MODE with the radio switched off, the function to be programmed blinks for about 15 seconds. During this time, adjust the setting with the UP/DOWN buttons. To apply a setting, just wait until the screen stops flashing (the screen reverts to the time indication) or press MODE to move on to the next function. Press the UP or DOWN button to move the time forward or backward at minute intervals. Hold down one of the buttons for a few seconds to move the setting forward or backward quickly at 10 minute intervals. If summer time is required, this can be set when setting the time zone. Press the UP or DOWN button to move the date forward or backward. Keep either of these buttons pressed for a few seconds to change the date in ten-day steps. Press the UP or DOWN button to move the time zone forward or backward. UTC is the reference for the times of the various time zones around the world. The screen shows the SUN OFF message when summer time has been deactivated. Summer time offset is now activated and the clock moves one hour ahead. Press MODE again or four times to show the world time. Press the UP or DOWN button to move the time zone forward or backward. Press the UP or DOWN button to set the date on which the alarm should sound. Press the SNOOZE button to ignore the year number setting so that the alarm sounds every year. When the current date tallies with the date of the SDA alarm, at 08. [. . . ] â· During the channel search press the FINE button, the screen shows FINE. â· Now, using the buttons UP resp. All stored stations will be played in succession for about five seconds. â· Press the button SNOOZE to finish the rendering of the memory positions. [. . . ]