User manual SILVERCREST KH 205

[. . . ] Never open batteries, never solder or weld batteries. If you do not intend to use the appliance for an extended period, remove the batteries. Do not use any aggressive chemical substances for cleaning. Use it only in dry rooms, do not use it when it is raining outdoors or when close to liquids. [. . . ] The precondition for this is that the sender and receiver within a system are working on the same frequency. For this, you must synchronise the appliances as follows: Press the synchronisation button on the receiver The red signal indicator now glows. The indicator f on the sender blinks a few times, then it goes out. If the synchronisation has been a success, the receiver notifies you of the programmed call signal. the appliances then conclude the synchronisation mode. Should the receiver not react as described, repeat the synchronisation. The sender shows, with a brief glowing of the indicator f when being activated, the transmission of the signal to the receiver. Installing the appliance Select a suitable positioning for the sender, close to your outer door. Using the assembly plate j of the sender, mark the positions required for the two boreholes (spacing approx. 68 mm) and then bore the holes for the enclosed wallplugs (S6). Screw the assembly plate j onto the wall. Carefully slide the plastic covering over the nameplate d to the side and then remove it. Write the name(s) of the residents on the plate d and then replace the plastic covering. Place the sender on the assembly plate j and secure it, with the enclosed small screws, to the assembly plate j. You can install the receiver at a suitable location either suspended by its loop o or make use of the stand t. Bear in mind that the given range refers to the free-space range. If being utilised in a building, this range is reduced quite distinctly. To suspend the receiver, fix the enclosed screw, with the wallplug, at a suitable location on the wall and hang the appliance from it. In the event of malfunction or apparent damage, make contact with Customer Services. If the appliance is not to be in use for an extended period, remove the batteries. NEVER submerse the appliance or its components in water or other fluids! â· Do not allow any liquids to penetrate into the appliance housing. [. . . ] You receive a 3-year warranty for this device as of the purchase date. The appliance has been manufactured with care and meticulously examined before delivery. Please retain your receipt as proof of purchase. In the case of a warranty claim, please make contact by telephone with our service department. [. . . ]