User manual SILVERCREST KH 2157

[. . . ] Important safety instructions Device summary Initial use Unpacking the device / checking the package contents Inserting the batteries Operating components LCD display Buttons SETUP - System settings Code Setup (Programming the remote control) Programming by brand code search Programming by manual code input Programming by automatic code search System-Setup Setting the time Setting the date Adjust contrast Background Illumination System reset Timer Setup Sleep timer Event timer Learn Setup Code learn function Macro Setup Favourites channel Volume control Vol +/--, (Mute switching) For operation All OFF Cleaning and storage Faults / Remedies Disposal Note regarding conformity Importer Technical data Warranty & Service All rights including those of photographic reproduction, duplication and distribution by means of particular methods (for example data processing, data carriers and data networks), wholly or partially as well as substantive and technical changes are reserved. Read the operating instructions carefully before using the device for the first time and preserve this booklet for later reference. Pass this manual on to whoever might acquire the device at a future date. Proper use Children may only operate the remote control under adult supervision. [. . . ] After entry of the 14th button the sequence will be automatically saved and "FULL" is shown in the LCD display q. In this menu also the device will return to the standard display after approx. The Universal remote control (URC) can learn and save button signals of an original remote control. If the URC does not work after applying the programming methods already described or cannot carry out all commands please attempt to teach the URC with the help of the original remote control. Maintain a distance of at least one metre from other light sources. The light sources could disrupt the infrared transmission. Place the URC and the original remote control at a distance of 20 to 50 mm from each other on an even surface so that the infrared diodes 1( are facing each other. Do not use the following buttons for the learn function: all device buttons e, MACRO i, S button r, EXIT y. When teaching please do not release the button of the original remote control until "SUCCESS" or "LEARN ERROR" appears in the LCD display q. If when teaching, during the notice "LEARNING", no button is pressed on the original RC after 25 seconds the learn menu will end. This mode can not be ended by pressing a button on the URC. If the memory is full the LCD display q shows "LEARN FULL" and the learn mode will end. With the EXIT button y you return to the previous status (except with a notice of "LEARN KEY" and/or "LEARNING"). Hold down the S button r for a little longer than 3 seconds. With the or button t select the menu "LEARN SETUP" and then press the OK button k. The URC now waits for the infrared signal from the original remote control. Note: Should the notice not change to "LEARNING" you have selected a button for which no button code can be taught. Point the infrared sensors 1( of both remote controls towards each other. Now hold down the desired button of the original remote control until "SUCCESS" or "LEARN ERROR" appears in the display q of the URC. If in the LCD display q "SUCCESS" appears (process successful), you can teach further buttons begining with step 5. If "LEARN ERROR" appears (process unsuccessful) repeat the process in any case from step 5. To stop the learning process press, during the display "LEARN SET", repeatedly the EXIT button y until the standard display is show in the LCD display q. [. . . ] The purpose of this obligation is to ensure that batteries are disposed of in a nonpolluting manner. Only dispose of batteries when they are fully discharged. This device satisfies the fundamental requirements and other relevant regulations of the EMC Directive 2004/108/EC. You receive a 3-year warranty for this appliance as of the purchase date. [. . . ]