User manual SILVERCREST KH 2190 V4

[. . . ] Retain these operating instructions and pass them on to any future owners with the appliance. GB IE Copyright This documentation is copyright protected. Any copying and/or reproduction, wholly or partially, as well as rendition of the illustrations, also in a modified form, is permitted only with written consent from the manufacturer. Intended use This appliance is intended only for listening to radio programmes and for alarm calls by signal tones or the radio in indoor rooms. This appliance is not intended for any other use or for uses beyond those mentioned. Claims of any kind for damage caused by improper use, incompetent repair, unauthorized modification or the use of unauthorized parts are excluded. [. . . ] Never submerge the appliance in water, do not place the appliance in the vicinity of water and do not stand any object filled with liquid (i. e. Do not place any objects on the appliance. Do not operate the appliance in the vicinity of open flames (i. e. Always pull on the power plug when disconnecting from the wall socket, never pull on the connection cable. If malfunctions occur or thunder storms threaten pull the power plug from the wall socket. GB IE KH 2190 7 Operating components GB IE Operating components OFF AL1/2 AL2 AL1-Switch: Activate/Deactivate Alarm 1 and/or Alarm 2 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 SNOOZE Button: Alarm interupt FM/AM Switch: Frequency band selection Display TUNING regulator: Station selection Wire antenna Frequency scale DOWN button: Adjustments downwards UP button: Adjustments upwards TIME button: Setting the time Battery compartment ON/OFF button: appliance on/off switch SLEEP button: Setting the automatic switch off AL. 2 button: Setting Alarm time 2 AL. 1 button: Setting Alarm time 1 VOLUME Regulator: Sound volume regulator/Alarm tone selector Power Cable 8 KH 2190 Setting up and connecting Setting up and connecting Package contents and transport inspection The appliance is delivered with the following components as standard: Clock Radio Operating instructions Extract the appliance and the instruction manual from the carton and remove all packaging material. NOTE Check the contents to ensure everything is present and there are no signs of visible damage. If the contents are not complete or are damaged as a result of defective packaging or through transportation, contact the Service Hotline (see chapter Service). GB IE Set-up location requirements For safe and fault free operation of the appliance the set-up location must comply with the following provisions: Place the appliance on a firm, flat and even surface . Place the appliance so that the ventilation slots are not covered. Do not place the appliance in a hot, wet or very humid location or in the vicinity of flammable materials. KH 2190 9 Setting up and connecting GB IE The surfaces of furniture may contain components that can affect the rubber pads of the appliance and could soften them. If necessary, place a covering under the appliance's rubber pads. The mains power socket must be easily accessible so that, in an emergency, the plug can be quickly withdrawn from the socket. Electrical connection Before connecting the appliance compare the connection data (Voltage and frequency) on the rating plate with that of the mains electric source. This data must be compatible to avoid possible damage to the appliance. Make sure that the appliance's connection cable is not damaged and is not laying over hot surfaces and/or sharp edges. Make sure that the connection cable is not tightly stretched or bent. Do not allow the connection cable to hang over edges (Trip wire effect). Inserting the battery By inserting a 9V Block battery (6LR61/6F22), in the event of a power failure you avoid losing the programmed time and alarm settings. The batteries ensures that the internal clock continues to run even during a power failure. When power is restored the correct time appears automatically in the display 4 . NOTE The display, radio and alarm do not function with batterypower alone. 10 KH 2190 Handling and operation Open the cover of the battery compartment 11 on the bottom of the appliance. Insert a 9V Block battery (not supplied) into the battery compartment 11 . Close the battery compartment 11 by replacing the cover and allowing it to lock into place. GB IE Providing mains power Plug the mains power plug into a wall socket. AL. 2 button 14 to return to the current time display. GB IE Switching the alarm function on Place the OFF AL1/2 AL2 AL1 switch in the desired position. As a control, a point appears in the display 4 to the left or right. KH 2190 13 Handling and operation GB IE Alarm call with the radio If you wish to be woken by the radio, carry out the following additional settings in addition to programming the alarm time: Press the ON/OFF button 12 to switch the appliance on. [. . . ] NOTE The warranty adjustment is valid only for material or manufacturing defects not, however, for transport damage, wear and tear or for damage to breakable parts, i. e. This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorised service branch. Your statutory rights are not restricted in any way by this warranty. [. . . ]