User manual SILVERCREST SAS 150 A1 ELECTRIC MULTI-PURPOSE SLICER

[. . . ] Blade protector Vario-switch for blade speed Switch for intermittent / continuous operation Knob for unlocking the blade covering Appliance housing Blade cover Cable winder / Cable depot Power cable The food to be sliced must be thawed, unpacked and free from bones before it can be sliced with the appliance. All other uses, and modifications to the appliance, are deemed to be improper usage and may result in serious physical injury. Supporting table with guide slot Foodstuff carriage Food holder plate with finger guard Cutting blade Food support plate Regulator (Infinite control slice-thickness controller) (Fig. ½ In the event of damage to the power cable 8 , the repair may only be carried out by the manufacturer, his service centre or a suitably qualified specialist. [. . . ] Press the pieces of food to be sliced forward using the food holder 11 . Use the slicer only for cutting normal household foods and not for other purposes. Do not use the slicer for cutting deep-frozen foods, bones, foods with large kernels or for the slicing of still packaged foods. Never use the slicer continuously for more than 10 minutes . The cutting blade 12 continues to rotate for a short while after the slicer has been switched off. For reasons of safety, the slice thickness must be returned to the , , 0" setting after use. Soft foodstuffs: Direct the food carriage 10 slowly against the cutter 12 . Soft foodstuffs, for example hams or cheeses, are best cut when they are at a low temperature / lightly chilled. Hard foodstuffs: With hard foodstuffs you can direct the food carriage 10 somewhat faster against the cutter 12 . You can thus quickly prepare your required amount of of sliced foods, for example salami, bread or gherkins. Low revolutions / Revolution symbol narrow end: Set a low revolution speed when you want to cut soft foodstuffs. Push the Vario-switch 2 completely in the direction of the sharp end. high revolutions / Revolution symbol wide end: Use a high revolution speed for slicing hard foodstuffs. Push the Vario-switch 2 completely in the direction of the broad end. Note: Between the maximum and minimum adjustments you can naturally also carry out further individual settings. Note: The two operating modes can be switched on and off with the rocker switch for intermittent / continuous operation 3 . The cutting blade 12 runs without it being necessary to hold the switch in this position. Halting continuous operation: Move the switch for intermittent / continuous operation 3 into the , , 0" position and wait until the cutting blade comes to a complete standstill. intermittent operation (switch for intermittent / continuous operation in position , , II"): Set the switch for intermittent / continuous operation 3 to position , , II". The cutting blade will continue to run for as long as the switch for intermittent / continuous operation is held in this position. Halting intermittent operation: Release the switch for intermittent / continuous operation 3 and wait until the cutting blade comes to a complete standstill. The settings on the scale do not correspond with the slice thickness in mm. [. . . ] The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. Your statutory rights are not restricted in any way by this warranty. The warranty period will not be extended by repairs made unter warranty. this applies also to replaced and repaired parts. [. . . ]