User manual SILVERCREST SDB 2000 A1 STEAM IRON

[. . . ] Never bend (kink) or crush the power cord. Arrange it in such a way that it can not come into contact with hot surfaces and such that no-one can step on it or trip over it. Always remove the power plug from the power socket after every use and when cleaning or filling. Always unroll the power cord fully before switching on and do not use an extension cord. [. . . ] To extend the optimal steam blast function, mix mains water with distilled water according to the table. Water hardness very soft / soft medium hard very hard Should the care instructions for an article of clothing not mention ironing, (Symbol ), you should not iron that clothing article. You could otherwise cause damage to the clothing article. Check the care instructions on the labels of the clothing article whether and at which temperature the clothing article may be ironed. The water hardness level can be queried at your local water works. Close the water reservoir filler opening y, making sure it "clicks" shut. You can dry iron without steam at all temperatures. Steam ironing is first possible at level 2 (· ), we however recommend level 3 (· ) should be used for steam ironing, because at this level the temperature to generate steam is optimal. Plug the power plug into a power socket of 220 - 230 V~/50 Hz. The control light for the temperature w lights up. When the control light goes out, the chosen temperature w has been reached. Wait until the temperature control light w goes out. This function is suitable for very dry, crumpled or creased materials. The steam spray is especially suited to smoothing places in the laundry that are difficult to access. This prevents water dripping from the soleplate. You must then re-set a suitable temperature with the temperature controller a. As soon as this is reached, steam production is continued. Additionally, if you set the steam iron down or just let it cool off, the drip-stop function prevents water leakage from the soleplate r. Never leave the steam iron unattended when it is hot or switched on. Only put the steam iron down on its standing foot e, fig. Let the iron warm up till the control light w cuts off and lights up again. Now steam and boiling water will start emerging from the steam escape holes at the gilding sole r. [. . . ] The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. Your statutory rights are not restricted in any way by this warranty. [. . . ]