User manual SILVERCREST SDRB 1000 A1 STEAM BRUSH

[. . . ] Read the operating instructions carefully before using the appliance for the first time and preserve this booklet for later reference. When the appliance is hot, grasp it only by the handle. This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. Children should be supervised to ensure that they do not play with the appliance. [. . . ] Using the measuring beaker t, fill the water tank 1 with mains water to the "Max" marking, but no further. NEVER fill the water tank 1 with chemical substances, cleaning agents or fluids other than mains water (or a mix of mains and distilled water). Close the water fill opening 2 to the water tank 1. ensure that the lug on the water fill opening 2 sits in the indentation on the lid. Only in this way is the water tank 1 properly closed. The water tank 1 must audibly engage with the unlocking device for the water tank 4. By pressing the steam blast button 8 you can now produce jets of steam. To release the first steam blast after heating the appliance up, it can happen that you may need to press the steam blast button 8 several times in succession. To use the steam and brush function, place the brush attachment w onto the steam brush. To do this, slide the brush attachment w all the way along the guide to the end. To be able to use the ironing function, remove the brush attachment w from the steam brush. To do this, press the unlocking device q downwards and, at the same time, pull the brush attachment w away to the front. The steam brush can be used with all clothing items. caution is to be exercised with heat-sensitive materials such as synthetics , polyamides or artificial silk. With these materials you should first check at a concealed part (inside seam) that the hot steam will not cause any damage to the garment. Do not touch these materials directly with the hot sole of the iron 0. Suspend the crumpled garment from a coat hanger. With one hand pull the garment flat, then steam it from top to bottom. Use light pressure with the clothes brush r and guide the appliance from top to bottom over the garment. You can thereby press the steam blast button 8 in short intervals. This must engage audibly with the unlocking device on the brush attachment q. Insert the power plug 7 into a correctly installed and earthed mains power socket. [. . . ] Fill the water tank 1 with water (See "Filling with water"). The steam brush does not heat itself up: the appliance is not connected to mains power. Insert the plug 7 into a wall power socket and set the desired temperature with the temperature regulator 3. Clean the housing with a soft, dry cloth only. [. . . ]