User manual SILVERCREST SED 3.7 A1

[. . . ] RISK OF ELECTRIC SHOCK Connect the appliance only to correctly installed mains power sockets supplying a current rating of 100 - 240 V ~ / 50/60 Hz. The power cable on this appliance cannot be replaced. In the event of it being damaged the whole appliance must be disposed of. In the event of operational malfunction, and for cleaning, always remove the plug from the mains power socket. [. . . ] the best time for epilation is in the evening after a shower. Then the skin is somewhat softened, so that the hairs can be plucked out easily. In addition, the skin can recover overnight, and any skin reddening will recede. Before epilation, treat the skin with a peeling or a massage glove. This helps remove dead skin cells, ingrowing hairs are avoided, and fine hairs stand proud. this enables the appliance to grip the hairs better. After epilation, nurture the skin with a moisturising lotion or cream. When the appliance is charged and the body part to be epilated is prepared: 1) Rub your hand once more against the growth direction of the hairs to be removed. Through this the hairs will be raised so that they can be better captured by the tweezers. 2) Remove the protective cap 1 from the epilator head 2. 3) Press the travel lock 5 and slide the speed switch 6 upwards to the desired speed level: Level 1: for sensitive areas (armpits and bikini line) Level 2: for legs 4) Hold the skin tight with one hand. 5) Place the epilator perpendicular to the skin and, without exerting any pressure, move it against the direction of the hair growth. Thereby, the side with the speed regulator 6 must face towards you. Do not make back and forth or circular movements. Always start anew and pass over the body part to be epilated several times, so that all of the hair is removed. NOTICE It may be that the hair grows back after a few days. The reason for this is that these hairs were too short to be removed during the last epilation session. 6) When you are finished with the treatment, place the speed switch 6 to "0". Thereby, ensure that the elongated depression on the protective cap lies on the elongated elevation on the front of the appliance. Otherwise, the cap does not hold correctly. RISK OF ELECTRIC SHOCK Before cleaning, disconnect the appliance from the mains adapter 9 and the mains adapter 9 from the main power supply. After every use clean the epilator head 2 with the supplied cleaning brush q to remove loose hairs. [. . . ] NOTICE The warranty applies to material or manufacturing faults only, not for transport damage, parts subject to wear and tear or for damage to fragile parts. This appliance is intended solely for domestic, not commercial, use. If this product has been subjected to improper or inappropriate handling, abuse, or modifications not carried out by one of our authorised service centres, the warranty will be considered void. Your statutory rights are not restricted in any way by this warranty. [. . . ]