User manual SILVERCREST SEKU 2000 A1 ELECTRIC FIREPLACE

[. . . ] Compliance with the instructions in this warning is necessary to avoid the risk of death or serious injury. A warning at this danger level indicates a potentially dangerous situation. If the dangerous situation is not avoided it can lead to injuries. The directives in this warning are there to avoid personal injuries. [. . . ] the recirculation of packaging into the material circuit saves on raw material and reduces generated waste. Dispose of packaging material that is no longer needed according to the regionally established regulations. If possible preserve the appliance's original packaging during the warranty period so that in the case of a warranty claim you can package the appliance properly for return. For the safe and correct operation of the appliance, the installation site must satisfy the following requirements: Do not place the appliance in a hot, wet or very humid environment or close to inflammable materials. The mains power socket must be easily accessible at all times, thus enabling the plug to be immediately withdrawn should an emergency situation arise. If the heater makes contact with flammable materials, there is a risk of fire!Pay heed to the following safety information to avoid these fire risks: Keep inflammable materials well away from the place of installation of the appliance. Before the first use NOTICE When you first use it, it may temporarily generate a light odour. For a safe and correct operation of the appliance, take note of the following instructions regarding the electrical connection: Before you connect the appliance, compare the connection data (voltage and frequency) on the plate with that of your electricity supplier. This data must tally, in order to avoid damage to the appliance. Ensure that the power cable is undamaged and that it is not placed over hot surfaces and/or sharp edges. NOTICE The operating elements are on the front of the appliance, above right and behind the ventilation grille. ON/OFF switch (Flames) ON/OFF switch (Heating, level 1) ON/OFF switch (Heating, level 2) Temperature control (Thermostat) Dimmer (for flame lamps) Before the appliance can be set up, the fire surround must be assembled. NOTICE Check the contents to make sure everything is there and for visible damage. Firstly, become familiar with all parts involved in the assembly. Left side panel left front panel top covering panel right front panel centre front panel Base plate Floor plate right side panel You require a screwdriver for the assembly; this is not supplied. Carry out the assembly step by step in the order as described. Screw three single locking pins Place two wood plugs With a screwdriver into the prepared holes on the left front panel Into the holes of the front panel Insert three adapter sleeves E into the three large holes of the left side panel . Thereby, with the screwdriver line up the adaptor sleeves E so that the arrow on the adaptor sleeves points to the outer edge of the side panel . Then, bring the front panel 2 and side panel together at right angles, so that the locking pins enter the holes on the left edge of the side panel . When done, screw all three adapter sleeves E to the right with the screwdriver until the locking pins are clamped into the adapter sleeves and the panels are seated firmly together and at right angles. Screw three single locking pins Place two wood plugs With a screwdriver into the prepared holes on the right front panel Into the holes of the front panel Insert three adapter sleeves into the three large holes of the right side panel 8 . [. . . ] Only in this way can a post-free despatch for your goods be assured. NOTICE The warranty is valid only for material or manufacturing defects not, however, for transport damage, wear and tear or for damage to breakable parts, i. This product is for private use only and is not intended for commercial applications. The warranty becomes void in the event of abusive and improper handling, use of force and internal tampering not carried out by our authorised service branch. [. . . ]