User manual SILVERCREST SHK 100 B2

[. . . ] It allows you to apply heat to specific areas of the body. This heating pad is not intended for use in hospitals or for commercial use. In particular it must not be used for babies or infants, persons who are Any use other than that described above or modification of the heating pad are not permissible and may lead to injury and / or damage to the heating pad. Failure to comply with the following instructions can cause personal injury or material damage (electric shock, skin burns, fire). [. . . ] NOTE: the heating pad is equipped with a safety system. The electronic sensor technology prevents the entire surface of the heating pad from overheating by automatically switching off in the event of a fault. If the safety system switches the heating pad off automatically as a result of a fault, the temperature display on the control 1 will no longer be illuminated when the heating pad is switched on. Safety system / Operation / Cleaning and care Please note that, for safety reasons, the heating pad must not be used after a fault and must be returned to the service address indicated. NOTE: The heating pad switches itself off automatically after about 90 minutes. The LED indicator on the control unit 1 shows "A". First select position "0" and after approx. 5 seconds select the required temperature level to switch the heating pad back on. Switch the heating pad off (Level "0") or take the mains plug out of the socket if you do not wish to use the heating pad after automatic switch-off. NOTE: the heating pad may smell of plastic the first time you use it, but this will disappear after a short period of time. To use the device, first connect the control unit 1 to the heating pad by plugging the plug-in connector 2 and the plug for the control unit 3 together (see Fig. Selecting the temperature: Set the highest temperature level (Level 6) shortly before use. If you are going to use the device for a number of hours, set it to the middle temperature setting (setting 3). Use the heating pad with the textile cover to prevent soiling or damage to the heating pad (particularly if using essential oils and creams). Before cleaning the heating pad, always pull the mains plug out of the mains socket and separate the plug-in connector 2 from the plug for the control unit 3 (see Fig. Do not reconnect the control 1 to the heating pad until the plug-in connector 2 and the heating pad are completely dry. There is otherwise a risk of an electric shock. Do not under any circumstances switch the heating pad on to dry help it dry. Do not use chemical cleaners or scouring agents to clean the heating pad or the control unit 1 . Otherwise the heating pad could be damaged. Never immerse the control unit 1 in water or other liquids. Do not hang the heating pad up to dry with pegs or similar. [. . . ] Repairs made after the expiration of the warranty period are subject to payment. Allow the heating pad to cool down before storage, otherwise material damage may occur. The packaging is made entirely of recyclable materials, which you may dispose of at local recycling facilities. Do not dispose of electrical devices with the household rubbish! [. . . ]