User manual SILVERCREST SNS 45 A1

[. . . ] 10 Risks from ultraviolet light (UV-Light) . These operating instructions are a component of the Nail Studio SNS 45 A1 (hereafter designated as the appliance) and they provide you with important information about the intended use, safety, connection and operation of the appliance. These operating instructions must be constantly kept available close to the appliance. They are to be read and applied by everyone assigned to operate the appliance and to eliminate faults in it. [. . . ] The nails, however, must be completely dry before the application. Before the application, refrain from using any hand creams or the like, because, to make possible the optimal adhesion of the nail tips o the nail surfaces must be completely free from greases. Push the cuticle back with the cuticle pusher w and then remove the transparent skin from the nail plate of your finger. Now treat the nail surface with the sanding block r until the fingernail is no longer shiny. Remove the sanding dust with a paper towel. Rub the nails with the finishing solution p so that the last remnants of dust and grease are removed. NOTICE Under no circumstance should you now touch the nail surfaces with your fingers, if you do, they will become greasy again and this will prevent a good bonding!Apply a small drop of nail glue a to the lower part of the nail tip o and distribute it with the aid of the nail glue bottle a on the lower surface. Hold the nail tip o down so that the nail glue a cannot run onto the upper part of the nail tip o. NOTICE Before the first use you must puncture the bottle of nail glue a with a pointed object, such as a needle. If, at a later date, the bottle of nail glue a has become blocked, it can again be opened for use with a needle. Now place the nail tip o at an angle on the natural nail, so that the predetermined edge of the nail tip o lies on the edge of the natural nail. Now tilt the nail tip o with gentle pressure onto the natural nail, so that potential air bubbles are squeezed out . NOTICE Wipe excess nail glue a off with a cotton swab or a paper towel. Hold the nail tip o firmly for 10-12 seconds and, at the same time, press it down with sufficient pressure onto the natural nail. Ensure that no air bubbles are formed and that the tip is glued on perfectly straight. NOTICE There may no longer be a gap under the nail, so that dirt cannot penetrate. ensure that no air bubbles or white spots form under the nail tip o. In this case, take the nail tip o off immediately and lay it back on again. When you have glued all of the artificial nails o on, trim them to the desired length with the nail clippers q. press the nail clippers q together in one squeeze. If you press too slowly, it may happen that the nail tips o splitter. [. . . ] UNDER NO CIRCUMSTANCES should you throw the appliance or the substances into normal household waste. This product is subject to the provisions of the European Directive 2002/96/EC-WEEE (Waste Electrical and Electronic Equipment). Dispose of the appliance and the substances via an approved waste disposal company or your communal waste disposal centre. The chemical substances are subject to special waste treatment. [. . . ]