User manual SILVERCREST SSOT 6 A1

[. . . ] Before reading, unfold both pages containing illustrations and familiarise yourself with all functions of the device. SET Year SET month SET day SET sleep disable Before getting started The following pictograms are used in these directions for use or on the device itself: Read the directions for use!Please observe the warning and safety instructions!Medical device type B Year and month of manufacture Dispose of the packaging and appliance in an environmentally friendly way! [. . . ] Pull the outer ear, tilted slightly upwards/to the rear, towards the back of his head, so that the ear canal is freely accessible and there are no impediments between the measurement sensor and the eardrum. Please keep the outer ear slightly extended and now carefully insert the measuring head 2 into the ear canal. Now you can read off the measurement result on the LC display 5 . Values can be displayed in °C as well as in °F (see "Functions / error analysis - selecting the temperature unit"). Wait until the display " " goes out before you start taking a new measurement. Note: The appliance automatically switches off if it is not operated for longer than 1 minute. When the sleep mode has been activated, the LC display 5 switches itself off. When the sleep mode has been deactivated, the appliance switches to standard mode. If the thermometer has been operated under normal conditions, the result of the last measurement taken before the appliance was switched off The measured value is available again along with information on the date, time and measurement mode when the "MEM / SET" button 1 is pressed again. It is advisable to carry out 3 measurements in a row at the same place and to take the highest temperature as the measured value. With different room temperatures, let the appliance lie in the room where the temperature is to be taken for at least 30 minutes to "acclimatise" it. Before measuring your body temperature, you should relax for about 5 minutes. If you have done any physical activity or taken a bath, wait for at least 30 minutes before taking a measurement in order to get a measurement that is as accurate as possible. Ensure that the forehead or temple is clean, free of injuries and not covered with sweat, cosmetics or ointment. Take a note of what measurement method you used to measure the temperature and inform your doctor of it. If the sleep mode has been activated, activate the thermometer again by pressing any button before taking the measurement. Carefully press on the protective cap 9 and remove it with a gentle rotary motion and without using any force. Check that the measuring head 2 and the measuring sensors are clean. Now you can read off the measurement result on the LC display 5 . Values can be displayed in °C as well as in °F (see "Functions / error analysis - selecting the temperature unit"). Repeat steps 3 to 6 to carry out further measurements. Note: The appliance automatically switches off if it is not operated for longer than 1 minute. [. . . ] It has been carefully produced and meti-culously checked before delivery. Please keep your receipt as proof of purchase. Contact your service centre by telephone in case of questions pertaining to the warranty. Your goods can be transmitted free of cost only in this manner. [. . . ]