User manual SILVERCREST SUV 1900 A1

[. . . ] They contain important information in regard to safety, use and disposal. Before using the product, familiarise yourself with all of these operating and safety instructions. Use the product only as described and only for the specified areas of application. In addition, pass these documents on, together with the product, to any future owner. [. . . ] The appliance is delivered with the following components as standard: Vacuum Sealer SUV 1900 A1 1 Tube film made of PE-HD (Polyethylene of high density) This operating manual NOTICE Check the contents to make sure everything is there and for visible damage. If the contents are not complete or are damaged due to defective packaging or through transportation, contact the service hotline (see chapter Service). DANGER Packaging material should not be used as a play thing by children. The packaging materials are selected from the point of view of their environmental friendliness and disposal technology and are therefore recyclable. The recirculation of packaging into the material circuit saves on raw material and reduces the amount of waste generated. dispose of packaging material that is no longer needed as per the regionally established regulations. NOTICE If possible preserve the appliance's original packaging during the warranty period so that in the case of a warranty claim you can package the appliance properly for return. For safe and flawless operation of the appliance, the installation site must comply with the following requirements: When setting it up, place the appliance on a firm, flat and horizontal surface. Do not operate the appliance in a hot, wet or very humid environment or close to combustible material. The mains power socket must be easily accessible, so that the power cable can be easily disconnected in the event of an emergency. IMPORTANT Before you connect the appliance, compare the connection data (voltage and frequency) on the data plate with that of your mains power network. nOTICE Check to ensure that the sealing seam is in order. A correct sealing seam should be a smooth, straight strip without folds. You must leave at least 6 cm free to the bag-edge that is to be sealed. IMPORTANT Fill the bags in such a way that, under no circumstances, food remnants or fluids can run out of the bag when sealing it and permeate into the appliance. If you do not want to vacuum seal the bag you can now seal the open side. When sealing, you can at the same time extract the air from the bag (vacuuming): IMPORTANT Do NOT vacuum bags in which there are liquids. They will permeate into the appliance and damage it. place the open end of the bag around the suction connectors . The bag needs to extend up to the marking "Vacuum", which is marked on the appliance. NOTICE and The bag opening must lie smoothly against the suction connectors the sealing wire . If it does not, the vacuuming and sealing will not work properly. [. . . ] Clean the collection container , as soon as contamination is visible: Open the appliance lid and lift the suction connectors Carefully pull the collection container side handles to pull it. Out of the appliance by using the Clean it in lukewarm washing-up water and then allow it to dry well. The appliance has a built-in cable winder on the underside of the housing, on which you can wrap the power cable when it is not in use. This prevents the power cable from being pinched, damaged or soiled, and it cannot become a source of danger by hanging loosely down. [. . . ]