User manual SILVERCREST SWEP 500 A1

[. . . ] Intended use Technical Data Symbols used Safety information Operating elements Starting up General functions Time functions Before using the device for the first time, read these operating instructions carefully and keep them for later reference. Hand the instructions over when transferring the device to a third party. Every copying, also as extracts, as well as any reproduction of images, even in an altered state, is only permitted with the written consent of the manufacturer. This appliance is intended for receiving generally approved radio transmissions in all countries (world receiver) and only for domestic use. [. . . ] You can continue to query and adjust the universal time, the date alarm, the mediumwave reception, alarm time interruption and the hours mode. When you press the button MODE with the radio switched off, the function to be programmed blinks for about 15 seconds. During this time, adjust the setting with the UP/DOWN buttons. To apply a setting, just wait until the screen stops flashing (the screen reverts to the time indication) or press MODE to move on to the next function. Press the UP or DOWN button to move the time forward or backward at minute intervals. Hold down one of the buttons for a few seconds to move the setting forward or backward quickly at 10 minute intervals. Press the UP or DOWN button to move the date forward or backward. Keep either of these buttons pressed for a few seconds to change the date in ten-day steps. Press the UP or DOWN button to move the time zone forward or backward. -10:00 -9:00 -8:00 -8:00 -7:00 -6:00 -6:00 -5:00 -5:00 -5:00 -4:30 -3:00 -3:00 0:00 0:00 1:00 1:00 1:00 2:00 2:00 3:00 3:00 4:00 5:00 6:00 7:00 8:00 8:00 8:00 8:00 9:00 10:00 11:00 12:00 no yes yes yes yes yes yes yes yes yes no yes no no yes yes yes yes yes yes yes no no no yes no no no no no no yes no yes UTC is the reference for the times of the various time zones around the world. Press MODE again or four times to show the world time. Press the UP or DOWN button to move the time zone forward or backward. To correctly present your set world time, you must set the summer time offset depending on the world time (see table). Not every time zone around the world differentiates between summer time and winter time. To correctly display your world time, you must set the summer time offset dependant on the time zone. When the display for the time zone is flashing, repeatedly press the SNOOZE button until the corresponding time offset is set (see table). Time offset 1 Display OFFSET 1 Explanation In your time zone (Local City) it is winter time and in the set world time it is summer time. In your time zone (Local City) and in the set world time it is summer resp. In your time zone (Local City) it is summer time and in the set world time it is winter time resp. Press the UP or DOWN button to set the date on which the alarm should sound. Press the SNOOZE button to ignore the year number setting so that the alarm sounds every year. When the current date tallies with the SDA alarm, on that day an alarm sounds for 10 minutes on every hour from 8:00 - 23:00. [. . . ] Risk of injury from electric shock: Disconnect the device from the mains power before cleaning it! Never immerse the device's parts into water or other liquids!Clean the housing surface with a slightly damp cloth. Never use petrol, solvent or detergents that could attack the plastic! [. . . ]