User manual SILVERCREST URC 801

[. . . ] 97 2 - English Universal Remote Control URC 801 Safety Instructions Before you use this device for the first time, please read the following notes in this manual and heed all warnings, even if you are familiar with handling electronic devices. Keep this manual safe for future reference. If you sell the device or pass it on, it is essential you hand over this manual also. Operating Environment Position the device on a stable, even surface and do not place any objects on the device. [. . . ] Press and hold down the button on the original remote control which you want to copy the signal from for at least 3 seconds. After releasing the button, the message [SUCCESS] or [FAILED] appears on the display. If you see the message [SUCCESS], the command has been programmed successfully. If necessary, you may repeat the last two steps English - 15 Universal Remote Control URC 801 to copy another command and assign it to a different button. If you see the message [FAILED], the command could not be programmed. Repeat these steps with the same button, but keep it pressed longer. After all the desired buttons have been programmed, quit the programming mode by pressing the EXIT button (28). It is not possible to exit programming while the universal remote control is still waiting for a command to be sent from the original remote control (the display shows [WAITING]). Quit the programming mode by pressing the EXIT button (28) three times. Erasing a Key Code You may erase a learned key code without altering any of the other programmed functions. Press the source device selection button (2) of the device for which you want to edit the programmed information. Press and hold the SET button (23) for at least 3 seconds. Press the button whose function you want to erase. The message [SURE DELET] will appear on the display. Press the OK button (27) to confirm the deletion. The message [DELETED] will appear for a few seconds and the device returns to the previous menu [SELECT KEY]. If required, continue erasing more key functions by pressing the corresponding button or quit the deletion process by pressing any source device selection button (2). 16 - English Universal Remote Control URC 801 Erasing All Key Codes for a Device This function allows you to erase all manuallylearned key commands for a specific device. Any buttons that have been programmed via a device code will not be erased. Press the source device selection button (2) of the device for which you want to erase all programmed information. Press and hold the SET button (23) for at least 3 seconds. Press the source device selection button (2) of the device for which you want to erase all programmed information. [. . . ] Enter the time via the numeric keys (3). The message [SUCCESS] will appear for a few seconds and the device returns to the [TIME SETUP] level. Quit the process by pressing the EXIT button (28) twice. 28 - English Universal Remote Control URC 801 Teletext Mode Use the TTX/MX button (38) to switch to Teletext mode. [. . . ]