User manual SIM2 DOMINO 20 INSTALL GUIDE

[. . . ] Installation manual STAND-BY Switches off to stand-by. 0-9 Keys Switch on from stand-by and allow direct source selection. ESCAPE Deactivates the On Screen Display. Up/Down/Left/Right Arrow keys Navigate through and make adjustments to the On Screen menus. [. . . ] This input accepts a Horizontal Scan Frequency of NC C-SY RGSB - YSCRCB COMPONENT VIDEO Fig. 19 This input is suitable for a RGB video signal, or for a Component (YCrCb) type, with composite synchronisation on the green signal (RGsB) or on the luminance (Y) signal (YsCrCb) through a cable with RCA/Phono type connector (Fig. 11 20 Only horizontal scanning frequencies of 15 kHz (standard video resolution) or 32 kHz (high definition video, with progressive scanning) can be applied to this input. MOTORISED PROJECTION SCREEN OUTPUT RS232 INTERFACE CONNECTOR It is possible to control the projector through a personal computer. First, load the appropriate projector control software onto your PC, then simply connect this input to a cable from your PC's RS232 serial port (Fig. 20 The projector is equipped with one output (Voltage: 12 Vdc) for motorised projection screen and screen. This 12V output should be connected to the appropriate screen interface provided by the screen manufacturer (Fig. The +12V output is activated when the projector is switched on (green LED on) and is de-activated when the projector is in stand-by mode (red LED on). Fig. 21 12 20 7 KEYBOARD PAD Eight push buttons, at the rear of the projector, will allow complete operation without the use of the remote control. Menu Activates the On Screen Display menus. Auto Selects Auto Adjust (automatic optimisation of the displayed image). Up/Down/Left/Right arrow keys Navigate through and make adjustments to the On Screen menus. Arrow Up/Down switch on from stand-by and recall Source Selection menu. -Focus-Esc De-activates the On Screen Display and gives access to the lens Zoom/Focus adjustment functions. 8 REMOTE CONTROL Insert the batteries, taking care to match the polarity, as indicated in the battery recess of the remote (Fig. batteries have leaked, carefully wipe the case clean and replace with new batteries. DVI + + + + - four 1. 5V AAA alkaline batteries Fig. 22 Change the batteries in the remote control if experiencing difficulty in sending commands to the projector. If the remote control is not to be used for a long period of time remove the batteries. Replace all batteries at the same time; do not replace one new battery with a used battery. If the The remote control sends commands to the projector via infrared signals. It is possible to control the projector by Fig. 23 pointing the remote control at the screen; the sensor at the front of the projector will pick up the reflected infrared commands. Avoid placing obstructions between the remote control and the infrared sensor at the front of the projector; this will impair the remote control performance. C-SYNC 13 20 9 ON SCREEN MENUS SOURCE SELECTION The Source Selection menu is recalled by pressing the key: 0/AV of the remote control or the Up/Down Arrow key of the keyboard pad. The selected source will be highlighted in yellow. Use Up and Down Arrow keys to browse sources. [. . . ] Incomplete image along borders (vertical and horizontal) - Compare compatibility of video/graphic signals and technical specifications of your projector. - Press Auto (on your remote or keypad) to execute automatic adjustments. - Adjust the horizontal and vertical position of projected image by selecting Position on the Image Adjustments menu. - Adjust the width and height of image, selecting Aspect in the Image Adjustments menu. 22 20 Image too dark, too pale or unnaturally coloured - Verify compatibility of video/graphic signals with technical specifications of your projector. [. . . ]