User manual SIMA CBS-500

[. . . ] All aspects as far as the safety and health of the users is concerned have been stated. Respecting all instructions and recommendations assures safety and low maintenance. As such, reading this manual carefully is compulsory for any person responsible for the use, maintenance or repair of this machine. As such, reading this manual carefully is compulsory for any person responsible for the use, maintenance or repair of this machine. [. . . ] the damaged electrical cables should be urgently replaced. Unplug the machine from the electricity and never manipulate nor operate on the mechanical nor electrical elements of the machine while the engine is on. Never use the machine for purposes other that those it has been designed for. Use normalised cables Make sure the feeding voltage is in accordance with the voltage indicated in the adhesive label on the machine. Make sure that the extension cords are not in contact with points of high temperature, oil, water, sharp edges. Also avoid trampling or crushing the cables by passing vehicles and do not put any objects on the machine. Do not use high pressure water to clean circuits or electrical elements. ATTENTION: You are to follow all safety recommendations mentioned in the present user manual and comply with all labour risks prevention norms in every location. The machine needs to be installed in well illuminated, stable and plane surface, free from any obstacles. Before starting-up the machine, we should have gone through all necessary safety measures (electrical connection, stability, protections, etc. ) as mentioned in the previous chapters. Let´s place the adjustable angle ruler which is supplied with the machine on the front of the sliding cart (B, Fig. Then fix the ruler to the sliding cart with the nut. The adjustable ruler can be adjusted on any side of the material. Place the piece to be cut on the cutting table making sure it remains stable and laying against the front ruler of the cutting table. Once the height of the cutting head has been adjusted and the piece placed on the cutting table, start-up the engine and make sure the cooling is adequate to the disk and material to cut. Learn how to stop the machine in a fast and safe way. Connect the machine to the electricity only when you are sure of its stability. Start the machine only when you have mounted the safety guards that come with the machine. It is recommended to use safety glasses, safety boots, gloves etc. Always use Individual Protection Equipment (IPE) in accordance with the type of work you are effectuating. prohibit strangers to access the place of work of the machine. [. . . ] Guarantees all its products against any manufacturing defect; to take into account the conditions stated in the attached document "WARRANTY CONDITIONS". The latter would cease in case of failure to comply with the established payment terms. Reserves its right to bring modifications and changes to its products without prior notice. The spare parts for the cutting table, model CBS-500, manufactured by SIMA, S. [. . . ]