User manual SIMA CDM-1

[. . . ] All liability for incidental or consequential damages is specifically excluded. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Limitation of Liability and Remedies Sima shall have no liability for any damages due to lost profits, loss of use or anticipated benefits, or other incidental, consequential, special or punitive damages arising from the use of, or the inability to use, this product, whether arising out of contract, negligence, tort or under any warranty, even if Sima has been advised of the possibility of such damages. [. . . ] Mounting plate - attaches to vehicle CD Platform with power supply 1 2 3 1. Voltage Switch - select 4. 5V, 6V or 9V 2. DC power supply - fits most portable CD players. Car cigarette lighter plug provides 12 V DC power 4 Green tip Blue tip Yellow tip DC plug adapters Hook and loop/velcro strips Check to make sure you have all the parts needed to install the CD mount. A 1. 5" extension pole and a 3. 5" extension pole !Owner's manual (this document) Installation Note: Installation of this CD stand requires drilling four small holes in your vehicle. You will need a power drill, a 1/8" drill bit and a Phillips head screwdriver. Step 6 - Set the voltage switch located on the underside of the mounting platform to the correct voltage for your portable player. 4. 5V 6V 9V Fig. F - Voltage selection switch Step 1 Assemble the components as shown in diagram A at right. Insert the raised tab on the stand into the corresponding hole on the bottom of the platform and slide toward center until firmly in place. A Step 7 - Select the DC Plug adapter that fits the DC IN jack on your portable player. Step 8 - Insert the DC Plug Adapter onto the DC power cord. Look closely at the markings on each side of the DC power cord and DC Plug adapter. To configure the connection To configure the connection as "Center Negative" make as "Center Positive", make sure the polarity markings sure the polarity markings are reversed ( "+" to "-" and match up same to same ( "+" to "+" and" -" to " -") as "+" to " -") as illustrated in Figure H below. illustrated in Figure G below. CDM - 1 cord CDM-1 cord Step 2 Choose a mounting location that will provide the most access and convenience for using your portable CD player in the vehicle. It must be close enough to the cigarette lighter for the lighter cord to reach. If necessary, use the 3. 5" extension provided. To change extension poles, loosen thumbscrew adjusters until fitting separates into two pieces ( Fig B). Insert 3. 5" extension and tighten until snug (Fig. H Center Negative Fig B Fig C Warning: Failure to observe polarity may cause damage to the mounting platform or your CD player. Step 3 After selecting a location on the vehicle to mount the stand, use the mounting plate as a template to mark the position of the four holes. Be sure no wires or cables are behind the surface before drilling. [. . . ] E, the polarity is center negative and the voltage is 4. 5V Fig. D DC IN 6V Green LED light on Car plug dims out !! External power short circuit Incorrect polarity of the output power Incorrect voltage supply to music player ! Check the portable player power supply including polarity Fig. E DC IN 4. 5 V Sounds bad ! ! Center pos. [. . . ]