User manual SIMA CT-200

[. . . ] #5 Oakmont, PA 15139 This warranty is void if any defects are caused by abuse, misuse, negligence or unauthorized repairs. All liability for incidental or consequential damages is specifically excluded. Some states do not allow for the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may have other rights, which vary from state to state. Digital Video Enhancer and Duplicator Sima Products Corporation 140 Pennsylvania Ave Bldg #5 Oakmont, PA 15139 800-345-7462 www. simacorp. com e-mail us at custserv@simacorp. com © 2005 Sima Products Corporation PN21712 Model CT-200 User Manual Congratulations on your purchase of Sima's GoDVD! [. . . ] will not perform the following functions: 1. Allow you to play a PAL DVD or video tape on a NTSC player. Allow you to play a PAL DVD or video tape on a NTSC TV that supports only 60 Hz scan. Allow you to copy an NTSC DVD or video tape to an NTSC DVD recorder or VCR in the PAL format to send over seas, unless the recorder supports both formats. 1 6 Important Connection Notes: · GoDVD!should be connected between your playback VCR, DVD or · · · camcorder and the recording VCR or DVD as shown on pages 3 & 4. Regardless of which input is used, both outputs continuously deliver an output signal. The unit will automatically detect whether the video input is in NTSC (USA) or PAL (Europe) format. Only the video cables are to be connected to GoDVD!. Audio cables should be connected directly between the playback and recording units. With Hi-8 or SVHS capability, connect your S-video cables to GoDVD!. The CT-200 is equipped with Auto Off/On signal detection. When the video signal is removed, the unit will automatically shut off and the LED will blink every 2 sec. When the video signal is restored, the unit will power on. Operation 1. Connect the GoDVD unit as shown on pages 3 and 4. Select the PAL/NTSC output format by setting the PAL/NTSC output switch to the desired setting. Note: The unit will automatically detect whether the input is PAL or NTSC, however you must select the desired output format. televisions, VCRs and DVDs, set the output format switch to NTSC. Select the appropriate input by pressing the Input select switch. Orange light signifies S-video input signal. Select the desired enhancement mode by pressing the Video Enhancement button. The button cycles between six enhancement modes as follows: 3. [. . . ] An orange blinking light indicates an S-video input signal with one of five enhancement modes. Use the steady indicator light as a fixed point to determine the desired enhancement mode. Review the chart below to determine the correct setting. If unsure which video enhancement mode is selected, look at your video monitor while toggling through the options. 2. [. . . ]